ramips: Support for RAMIPS based Tripmate HT-TM02 board

Provides support for the Tripmate HT-TM02 personal router including LEDs and
reset button. “Mode” switch is not supported. New profile includes full set
of packages required to enable LEDs, USB, and LUCI. Patches were applied
against trunk snapshot r42649. Functionality has been tested in AP, basic wifi
client, wifi router, and routed client modes - all good.

Signed-off-by: Ron Curry <wingspinner@gmail.com>
SVN-Revision: 42785

diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds
index bf646ed53b50e45d49e2a35236fead5fa18c8fc3..ecaaaff764af6983a618e9902a4e426c518e8c59 100755 (executable)
--- a/target/linux/ramips/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/base-files/etc/board.d/01_leds
@@ -112,6 +112,10 @@ case $board in
        hlk-rm04)
                set_wifi_led "rt2800pci-phy0::radio"
                ;;
+        ht-tm02)
+               ucidef_set_led_netdev "eth" "ETH" "ht-tm02:white:status" "eth0"
+               set_wifi_led "ht-tm02:blue:wifi"
+                ;;
        all0239-3g|\
        hw550-3g)
                set_usb_led "hw550-3g:green:usb"

diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network
index e027b3be89fedafff3d17a2348c2827bc2e0c78f..c462fd8142e16d72c496c4445b651c8aae977ca2 100755 (executable)
--- a/target/linux/ramips/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/base-files/etc/board.d/02_network
@@ -97,6 +97,12 @@ ramips_setup_interfaces()
                ucidef_add_switch_vlan "switch0" "2" "4 9t"
                ;;
 
+       ht-tm02)
+               ucidef_set_interface_lan "eth0.1"
+               ucidef_add_switch "switch0" "1" "1"
+               ucidef_add_switch_vlan "switch0" "1" "4 6t"
+               ;;
+
        3g-6200n | \
        dir-610-a1 | \
        dir-300-b7 | \
@@ -253,6 +259,7 @@ ramips_setup_macs()
        hlk-rm04 | \
        mpr-a1 | \
        mpr-a2 | \
+        ht-tm02 | \
        dir-300-b7 | \
        dir-320-b1 | \
        psr-680w |\

diff --git a/target/linux/ramips/base-files/etc/diag.sh b/target/linux/ramips/base-files/etc/diag.sh
index 9ad7ccbda1042a1bfce2f4e53979f2113d706269..9752eb22ecc078de097e957b530562f77b919bea 100755 (executable)
--- a/target/linux/ramips/base-files/etc/diag.sh
+++ b/target/linux/ramips/base-files/etc/diag.sh
@@ -63,6 +63,9 @@ get_status_led() {
        hlk-rm04)
                status_led="hlk-rm04:red:power"
                ;;
+       ht-tm02)
+               status_led="ht-tm02:white:status"
+               ;;
        all0239-3g|\
        hw550-3g)
                status_led="hw550-3g:green:status"

diff --git a/target/linux/ramips/base-files/lib/ramips.sh b/target/linux/ramips/base-files/lib/ramips.sh
index bb42ace621eead2360f3152694a9ccb9f07ebec7..68ff509a4efb648c0b8412a30137ecca0d25934b 100755 (executable)
--- a/target/linux/ramips/base-files/lib/ramips.sh
+++ b/target/linux/ramips/base-files/lib/ramips.sh
@@ -157,6 +157,9 @@ ramips_board_detect() {
        *"HILINK HLK-RM04")
                name="hlk-rm04"
                ;;
+       *"HOOTOO HT-TM02")
+               name="ht-tm02"
+               ;;
        *"HAME MPR-A1")
                name="mpr-a1"
                ;;

diff --git a/target/linux/ramips/base-files/lib/upgrade/platform.sh b/target/linux/ramips/base-files/lib/upgrade/platform.sh
index 407c21838afc952b02b0bbff30af2ca1146b90b2..4aec78099a45f1faa110d2c574d8412cc001225d 100755 (executable)
--- a/target/linux/ramips/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ramips/base-files/lib/upgrade/platform.sh
@@ -52,6 +52,7 @@ platform_check_image() {
        hw550-3g | \
        hg255d | \
        hlk-rm04 | \
+       ht-tm02 | \
        ip2202 | \
        m3 | \
        m4 | \

diff --git a/target/linux/ramips/dts/HT-TM02.dts b/target/linux/ramips/dts/HT-TM02.dts
new file mode 100644 (file)
index 0000000..1f456f0
--- /dev/null
+++ b/target/linux/ramips/dts/HT-TM02.dts
@@ -0,0 +1,104 @@
+/dts-v1/;
+
+/include/ "rt5350.dtsi"
+
+/ {
+       compatible = "HT-TM02", "ralink,rt5350-soc";
+       model = "HOOTOO HT-TM02";
+
+       palmbus@10000000 {
+
+               gpio0: gpio@600 {
+                       status = "okay";
+               };
+               
+               spi@b00 {
+                       status = "okay";
+                       m25p80@0 {
+                               #address-cells = <1>;
+                               #size-cells = <1>;
+                               compatible = "mx25l6405d";
+                               reg = <0 0>;
+                               linux,modalias = "m25p80", "mx25l6405d";
+                               spi-max-frequency = <10000000>;
+
+                               partition@0 {
+                                       label = "u-boot";
+                                       reg = <0x0 0x30000>;
+                                       read-only;
+                               };
+
+                               partition@30000 {
+                                       label = "u-boot-env";
+                                       reg = <0x30000 0x10000>;
+                                       read-only;
+                               };
+
+                               factory: partition@40000 {
+                                       label = "factory";
+                                       reg = <0x40000 0x10000>;
+                                       read-only;
+                               };
+
+                               partition@50000 {
+                                       label = "firmware";
+                                       reg = <0x50000 0x7b0000>;
+                               };
+                       };
+               };
+       };
+
+       pinctrl {
+               state_default: pinctrl0 {
+                       gpio {
+                               ralink,group = "i2c", "jtag", "uartf";
+                               ralink,function = "gpio";
+                       };
+               };
+       };
+
+       ethernet@10100000 {
+               mtd-mac-address = <&factory 0x4>;
+       };
+
+       esw@10110000 {
+               ralink,portmap = <0x3f>;
+       };
+
+       wmac@10180000 {
+               ralink,mtd-eeprom = <&factory 0>;
+       };
+
+       ehci@101c0000 {
+               status = "okay";
+       };
+
+       ohci@101c1000 {
+               status = "okay";
+       };
+
+       gpio-leds {
+               compatible = "gpio-leds";
+               wifi  {
+                       label = "ht-tm02:blue:wifi";
+                       gpios = <&gpio0 7 1>;
+               };
+               status  {
+                       label = "ht-tm02:yellow:status";
+                       gpios = <&gpio0 12 1>;
+               };
+
+       };
+
+       gpio-keys-polled {
+               compatible = "gpio-keys-polled";
+               #address-cells = <1>;
+               #size-cells = <0>;
+               poll-interval = <20>;
+               wps {
+                       label = "reset";
+                       gpios = <&gpio0 10 1>;
+                       linux,code = <0x198>;
+               };
+       };
+};

diff --git a/target/linux/ramips/image/Makefile b/target/linux/ramips/image/Makefile
index 35057e49e486ae44ea89b7e0a6d8b984921ec459..c365d9dbb59e354457da921eebc28714206092e9 100644 (file)
--- a/target/linux/ramips/image/Makefile
+++ b/target/linux/ramips/image/Makefile
@@ -434,6 +434,8 @@ define BuildFirmware/HLKRM04/initramfs
 endef
 Image/Build/Profile/HLKRM04=$(call BuildFirmware/HLKRM04/$(1),$(1),hlk-rm04,HLKRM04,HLK-RM02)
 
+Image/Build/Profile/HT-TM02=$(call BuildFirmware/Default8M/$(1),$(1),ht-tm02,HT-TM02)
+
 Image/Build/Profile/M3=$(call BuildFirmware/Poray4M/$(1),$(1),m3,M3)
 
 Image/Build/Profile/M4=$(call BuildFirmware/PorayDualSize/$(1),$(1),m4,M4)
@@ -598,6 +600,7 @@ define Image/Build/Profile/Default
        $(call Image/Build/Profile/FREESTATION5,$(1))
 #      $(call Image/Build/Profile/HG255D,$(1))
        $(call Image/Build/Profile/HLKRM04,$(1))
+       $(call Image/Build/Profile/HT-TM02,$(1))
        $(call Image/Build/Profile/HW550-3G,$(1))
        $(call Image/Build/Profile/IP2202,$(1))
        $(call Image/Build/Profile/M3,$(1))

diff --git a/target/linux/ramips/rt305x/profiles/hootoo.mk b/target/linux/ramips/rt305x/profiles/hootoo.mk
new file mode 100644 (file)
index 0000000..976226d
--- /dev/null
+++ b/target/linux/ramips/rt305x/profiles/hootoo.mk
@@ -0,0 +1,28 @@
+#
+# Copyright (C) 2013 OpenWrt.org
+#
+# This is free software, licensed under the GNU General Public License v2.
+# See /LICENSE for more information.
+#
+
+
+define Profile/HT-TM02
+       NAME:=HOOTOO HT-TM02
+       PACKAGES:=\
+               wpad-mini \
+               kmod-ledtrig-netdev kmod-ledtrig-timer kmod-leds-gpio kmod-ledtrig-default-on \
+               kmod-usb-core kmod-usb-ohci kmod-usb2 kmod-usb-net usbutils \
+               kmod-scsi-core kmod-scsi-generic kmod-fs-ext4 \
+               kmod-usb-storage kmod-usb-storage-extras block-mount \
+               kmod-usb-serial kmod-usb-serial-ftdi kmod-gpio-button-hotplug \
+               kmod-nls-cp437 kmod-nls-iso8859-1 kmod-nls-utf8 luci luci-mod-admin-full \
+               kmod-app-samba luci-theme-openwrt luci-proto-relay relayd nano \
+               fstools 
+endef
+
+define Profile/HT-TM02/Description
+       Package set for HOOTOO HT-TM02 board
+endef
+
+$(eval $(call Profile,HT-TM02))
+