Previously, we would store the operating mode at interface up time,
but only update the PCU registers when the next reset happened.
The result is that if beacon configuration (ops->bss_info_changed)
happens before ops->config, we will program the wrong things into
the timer registers. Consequently, beacons won't work in AP mode
until after a reset (channel change, scan etc.).
This is fragile anyway so just program the opmode as soon as
mac80211 gives it to us.
Signed-off-by: Bob Copeland <me@bobcopeland.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
struct ath5k_hw *ah = sc->ah;
u32 rfilt;
+ ah->ah_op_mode = sc->opmode;
+
/* configure rx filter */
rfilt = sc->filter_flags;
ath5k_hw_set_rx_filter(ah, rfilt);
}
ath5k_hw_set_lladdr(sc->ah, conf->mac_addr);
+ ath5k_mode_setup(sc);
ret = 0;
end: