ramips: rt288x: use flash location for wan_mac in 02_network

This uses the flash locations instead of eth0 MAC address to
calculate MAC address increments for WAN.

The change will make the MAC address setup of a particular device
more obvious and removes the dependency of 02_network on the eth0
initialization.

This removes the wan_mac setup for ralink,v11st-fe as this device
does not set up a MAC address for ethernet in the first place.

Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>

diff --git a/target/linux/ramips/rt288x/base-files/etc/board.d/02_network b/target/linux/ramips/rt288x/base-files/etc/board.d/02_network
index b9588f4aad4764d552fa0acac8e7fa331a50d265..0cc0e0b28b6989403b3fdb0ab703914d81786868 100755 (executable)
--- a/target/linux/ramips/rt288x/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/rt288x/base-files/etc/board.d/02_network
@@ -42,13 +42,14 @@ ramips_setup_macs()
        local label_mac=""
 
        case $board in
-       airlink101,ar670w|\
+       airlink101,ar670w)
+               wan_mac=$(macaddr_add "$(mtd_get_mac_binary factory 0x2004)" 1)
+               ;;
        airlink101,ar725w|\
        asus,rt-n15|\
        belkin,f5d8235-v1|\
-       buffalo,wzr-agl300nh|\
-       ralink,v11st-fe)
-               wan_mac=$(macaddr_add "$(cat /sys/class/net/eth0/address)" 1)
+       buffalo,wzr-agl300nh)
+               wan_mac=$(macaddr_add "$(mtd_get_mac_binary factory 0x4)" 1)
                ;;
        esac