Add interrupt controller properties now that ssbi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.
This change was tested on an APQ8060 DragonBoard.
Signed-off-by: Brian Masney <masneyb@onstation.org>
Tested-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
compatible = "qcom,pm8058-gpio",
"qcom,ssbi-gpio";
reg = <0x150>;
- interrupt-parent = <&pm8058>;
- interrupts = <192 IRQ_TYPE_NONE>,
- <193 IRQ_TYPE_NONE>,
- <194 IRQ_TYPE_NONE>,
- <195 IRQ_TYPE_NONE>,
- <196 IRQ_TYPE_NONE>,
- <197 IRQ_TYPE_NONE>,
- <198 IRQ_TYPE_NONE>,
- <199 IRQ_TYPE_NONE>,
- <200 IRQ_TYPE_NONE>,
- <201 IRQ_TYPE_NONE>,
- <202 IRQ_TYPE_NONE>,
- <203 IRQ_TYPE_NONE>,
- <204 IRQ_TYPE_NONE>,
- <205 IRQ_TYPE_NONE>,
- <206 IRQ_TYPE_NONE>,
- <207 IRQ_TYPE_NONE>,
- <208 IRQ_TYPE_NONE>,
- <209 IRQ_TYPE_NONE>,
- <210 IRQ_TYPE_NONE>,
- <211 IRQ_TYPE_NONE>,
- <212 IRQ_TYPE_NONE>,
- <213 IRQ_TYPE_NONE>,
- <214 IRQ_TYPE_NONE>,
- <215 IRQ_TYPE_NONE>,
- <216 IRQ_TYPE_NONE>,
- <217 IRQ_TYPE_NONE>,
- <218 IRQ_TYPE_NONE>,
- <219 IRQ_TYPE_NONE>,
- <220 IRQ_TYPE_NONE>,
- <221 IRQ_TYPE_NONE>,
- <222 IRQ_TYPE_NONE>,
- <223 IRQ_TYPE_NONE>,
- <224 IRQ_TYPE_NONE>,
- <225 IRQ_TYPE_NONE>,
- <226 IRQ_TYPE_NONE>,
- <227 IRQ_TYPE_NONE>,
- <228 IRQ_TYPE_NONE>,
- <229 IRQ_TYPE_NONE>,
- <230 IRQ_TYPE_NONE>,
- <231 IRQ_TYPE_NONE>,
- <232 IRQ_TYPE_NONE>,
- <233 IRQ_TYPE_NONE>,
- <234 IRQ_TYPE_NONE>,
- <235 IRQ_TYPE_NONE>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
gpio-controller;
#gpio-cells = <2>;