Fixes ARV7519RW22 flash register (only 1 flash).
Power LED is green, not red.
Rename message LEDs to internet.
Add LEDs configuration (lan, wan, power).
Enable switch VLANs.
Fix secondary USB.
Signed-off-by: Álvaro Fernández Rojas <noltari@gmail.com>
Signed-off-by: José Vázquez Fernández <ppvazquezfer@gmail.com>
SVN-Revision: 47132
ucidef_set_led_netdev "dsl" "dsl" "dsl" "nas0"
ucidef_set_led_netdev "internet_green" "internet_green" "internet_green" "pppoe-wan"
;;
+ARV7519RW22)
+ ucidef_set_led_default "power" "power" "power" "1"
+ ucidef_set_led_netdev "internet_green" "internet_green" "internet_green" "pppoe-wan"
+ ucidef_set_led_netdev "lan" "lan" "lan" "eth0.1"
+ ;;
ARV8539PW22)
ucidef_set_led_default "power" "power" "soc:green:power" "1"
ucidef_set_led_default "power2" "power2" "soc:red:power" "0"
ARV7519RW22)
lan_mac=$(mtd_get_mac_binary boardconfig 22)
wan_mac=$(macaddr_add "$lan_mac" 1)
+ ucidef_set_interface_lan "eth0.1"
+ ucidef_add_switch "switch0" "1" "1"
+ ucidef_add_switch_vlan "switch0" "1" "0 2 3 4 5 6t"
;;
BTHOMEHUBV2B|BTHOMEHUBV3A)
nor-boot@0 {
compatible = "lantiq,nor";
bank-width = <2>;
- reg = <0 0x0 0x2000000>, <1 0x2000000 0x2000000>;
+ reg = <0 0x0 0x2000000>;
#address-cells = <1>;
#size-cells = <1>;
ifxhcd@E101000 {
status = "okay";
gpios = <&gpio 32 0>;
- lantiq,portmask = <0x3>;
+ };
+
+ ifxhcd@E106000 {
+ status = "okay";
+ gpios = <&gpio 32 0>;
};
pcie@d900000 {
label = "lan";
gpios = <&gpio 2 1>;
};
- message_red {
- label = "message_red";
+ internet_red {
+ label = "internet_red";
gpios = <&gpio 10 1>;
};
- power_red {
+ power_green {
label = "power";
gpios = <&gpio 14 1>;
default-state = "on";
label = "alarm";
gpios = <&gpio 15 1>;
};
- message_orange {
- label = "message_orange";
+ internet_orange {
+ label = "internet_orange";
gpios = <&gpio 19 1>;
};
- message_green {
- label = "message_green";
+ internet_green {
+ label = "internet_green";
gpios = <&gpio 28 1>;
};
voice_green {