arm64: defconfig: Enable FSL_EDMA driver

Enables the FSL EDMA driver by default.  This also works around an issue
that imx-i2c driver keeps deferring the probe because of the DMA is not
ready.  And currently the DMA engine framework can not correctly tell
if the DMA channels will truly become available later (it will never be
available if the DMA driver is not enabled).

This will cause indefinite messages like below:
[    3.335829] imx-i2c 2180000.i2c: can't get pinctrl, bus recovery not supported
[    3.344455] ina2xx 0-0040: power monitor ina220 (Rshunt = 1000 uOhm)
[    3.350917] lm90 0-004c: 0-004c supply vcc not found, using dummy regulator
[    3.362089] imx-i2c 2180000.i2c: can't get pinctrl, bus recovery not supported
[    3.370741] ina2xx 0-0040: power monitor ina220 (Rshunt = 1000 uOhm)
[    3.377205] lm90 0-004c: 0-004c supply vcc not found, using dummy regulator
[    3.388455] imx-i2c 2180000.i2c: can't get pinctrl, bus recovery not supported
.....

Signed-off-by: Li Yang <leoyang.li@nxp.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig
index 4d583514258ce57b1edcde391aba9ce0d4211b3e..6bca5b082ea4e6a84430568c89b7532f9e076d62 100644 (file)
--- a/arch/arm64/configs/defconfig
+++ b/arch/arm64/configs/defconfig
@@ -613,6 +613,7 @@ CONFIG_RTC_DRV_TEGRA=y
 CONFIG_RTC_DRV_IMX_SC=m
 CONFIG_RTC_DRV_XGENE=y
 CONFIG_DMADEVICES=y
+CONFIG_FSL_EDMA=y
 CONFIG_DMA_BCM2835=m
 CONFIG_K3_DMA=y
 CONFIG_MV_XOR=y