dt-bindings: serial: document fsl,inverted-tx and -rx options

Add a description for the new fsl,inverted-tx and fsl,inverted-rx
options for the i.MX UART peripheral.

Signed-off-by: George Hilliard <ghilliard@kopismobile.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Link: https://lore.kernel.org/r/20200226222319.18383-2-ghilliard@kopismobile.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
index 35957cbf1571e4f674e7e6602807cabad140f78f..c8d677f9491fb293f20c7b065d1ed783262402e0 100644 (file)
--- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
+++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
@@ -8,6 +8,10 @@ Required properties:
 Optional properties:
 - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works
                   in DCE mode by default.
+- fsl,inverted-tx , fsl,inverted-rx : Indicate that the hardware attached
+  to the peripheral inverts the signal transmitted or received,
+  respectively, and that the peripheral should invert its output/input
+  using the INVT/INVR registers.
 - rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx,
   linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485
   you must enable either the "uart-has-rtscts" or the "rts-gpios"