The OpenWrt wireless configuration for mcast_rate is defined as Kbit/s when
using wpa_supplicant for IBSS/802.11s and iw for unencrypted IBSS/802.11s.
But when using authsae, the unit for the same option is redefined as
Mbit/s. Better use the same unit for this option independent of the backend
which is used.
Old values for mcast_rate (< 1000) are still interpreted Mbit/s to avoid
problems during upgrades from older versions.
Signed-off-by: Sven Eckelmann <sven@open-mesh.com>
SVN-Revision: 47614
local ret=1
json_get_vars mcast_rate mesh_id
- set_default mcast_rate "12"
+ set_default mcast_rate "12000"
case "$htmode" in
HT20|HT40+|HT40-) mesh_htmode="$htmode";;
*a*) mesh_band=11a;;
esac
+ if [ "$mcast_rate" -gt 1000 ]; then
+ # authsae only allows integers as rates and not things like 5.5
+ mcval=$(($mcast_rate / 1000))
+ else
+ # compat: to still support mbit/s rates
+ mcval="$mcast_rate"
+ fi
+
cat > "$authsae_conf_file" <<EOF
authsae:
{
band = "$mesh_band";
channel = $channel;
htmode = "$mesh_htmode";
- mcast-rate = $mcast_rate;
+ mcast-rate = $mcval;
};
};
EOF