--- /dev/null
+/*
+ * wb45n.dts - Device Tree file for WB45NBT board
+ *
+ * Copyright (C) 2015 Laird
+ *
+ * Licensed under GPLv2 or later.
+ */
+/dts-v1/;
+#include "at91sam9g25.dtsi"
+
+/ {
+ model = "Laird Workgroup Bridge 45N - Atmel AT91SAM (dt)";
+ compatible = "laird,wb45n", "laird,wbxx", "atmel,at91sam9x5", "atmel,at91sam9";
+
+ chosen {
+ bootargs = "console=ttyS0,115200 root=/dev/mtdblock1 rw rootfstype=ubifs ubi.mtd=1 root=ubi0:rootfs";
+ };
+
+ memory {
+ reg = <0x20000000 0x4000000>;
+ };
+
+ clocks {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+
+ main_clock: clock@0 {
+ compatible = "atmel,osc", "fixed-clock";
+ clock-frequency = <12000000>;
+ };
+
+ slow_xtal {
+ clock-frequency = <32768>;
+ };
+
+ main_xtal {
+ clock-frequency = <12000000>;
+ };
+ };
+
+ ahb {
+ apb {
+
+ rstc@fffffe00 {
+ compatible = "atmel,sama5d3-rstc";
+ };
+
+ pinctrl@fffff400 {
+ nand {
+ pinctrl_nand: nand-0 {
+ atmel,pins =
+ <AT91_PIOD 0 AT91_PERIPH_A AT91_PINCTRL_NONE /* PD0 periph A Read Enable */
+ AT91_PIOD 1 AT91_PERIPH_A AT91_PINCTRL_NONE /* PD1 periph A Write Enable */
+ AT91_PIOD 2 AT91_PERIPH_A AT91_PINCTRL_NONE /* PD2 periph A Address Latch Enable */
+ AT91_PIOD 3 AT91_PERIPH_A AT91_PINCTRL_NONE /* PD3 periph A Command Latch Enable */
+ AT91_PIOD 4 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP /* PD4 gpio Chip Enable pin pull_up */
+ AT91_PIOD 5 AT91_PERIPH_GPIO AT91_PINCTRL_PULL_UP>; /* PD5 gpio RDY/BUSY pin pull_up */
+ };
+ };
+
+ usb2 {
+ pinctrl_board_usb2: usb2-board {
+ atmel,pins =
+ <AT91_PIOB 11 AT91_PERIPH_GPIO AT91_PINCTRL_DEGLITCH>; /* PB11 gpio vbus sense, deglitch */
+ };
+ };
+ };
+
+ dbgu: serial@fffff200 {
+ status = "okay";
+ };
+
+ usart0: serial@f801c000 {
+ status = "okay";
+ };
+
+ usart3: serial@f8028000 {
+ status = "okay";
+ };
+
+ spi0: spi@f0000000 {
+ status = "okay";
+ cs-gpios = <&pioA 14 0>, <&pioA 7 0>, <0>, <0>;
+ };
+
+ mmc0: mmc@f0008000 {
+ pinctrl-0 = <
+ &pinctrl_mmc0_slot0_clk_cmd_dat0
+ &pinctrl_mmc0_slot0_dat1_3>;
+ status = "okay";
+ /delete-property/dmas;
+ /delete-property/dma-names;
+ slot@0 {
+ reg = <0>;
+ bus-width = <4>;
+ };
+ };
+
+ macb0: ethernet@f802c000 {
+ phy-mode = "rmii";
+ status = "okay";
+ };
+
+ usb2: gadget@f803c000 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_board_usb2>;
+ atmel,vbus-gpio = <&pioB 11 GPIO_ACTIVE_HIGH>;
+ status = "okay";
+ };
+
+ i2c1: i2c@f8014000 {
+ status = "okay";
+ };
+
+ watchdog@fffffe40 {
+ status = "okay";
+ };
+
+ shdwc@fffffe10 {
+ atmel,wakeup-mode = "low";
+ };
+
+ rtc@fffffeb0 {
+ status = "okay";
+ };
+ };
+
+ usb0: ohci@00600000 {
+ status = "okay";
+ num-ports = <2>;
+ atmel,vbus-gpio = <
+ &pioB 12 GPIO_ACTIVE_HIGH
+ &pioA 31 GPIO_ACTIVE_HIGH
+ >;
+ atmel,oc-gpio = <&pioB 13 GPIO_ACTIVE_LOW>;
+ };
+
+ usb1: ehci@00700000 {
+ status = "okay";
+ };
+
+ nand0: nand@40000000 {
+ nand-bus-width = <8>;
+ nand-ecc-mode = "hw";
+ atmel,has-pmecc; /* Enable PMECC */
+ atmel,pmecc-cap = <4>;
+ atmel,pmecc-sector-size = <512>;
+ nand-on-flash-bbt;
+ status = "okay";
+
+ at91bootstrap@0 {
+ label = "at91bs";
+ reg = <0x0 0x20000>;
+ };
+
+ uboot@20000 {
+ label = "u-boot";
+ reg = <0x20000 0x80000>;
+ };
+
+ ubootenv@a0000 {
+ label = "u-boot-env";
+ reg = <0xa0000 0x20000>;
+ };
+
+ ubootenv@c0000 {
+ label = "redund-env";
+ reg = <0xc0000 0x20000>;
+ };
+
+ kernel-a@e0000 {
+ label = "kernel-a";
+ reg = <0xe0000 0x280000>;
+ };
+
+ kernel-b@360000 {
+ label = "kernel-b";
+ reg = <0x360000 0x280000>;
+ };
+
+ rootfs-a@5e0000 {
+ label = "rootfs-a";
+ reg = <0x5e0000 0x2600000>;
+ };
+
+ rootfs-b@2be0000 {
+ label = "rootfs-b";
+ reg = <0x2be0000 0x2600000>;
+ };
+
+ user@51e0000 {
+ label = "user";
+ reg = <0x51e0000 0x2dc0000>;
+ };
+
+ logs@7fa0000 {
+ label = "logs";
+ reg = <0x7fa0000 0x60000>;
+ };
+ };
+ };
+
+ atheros {
+ compatible = "atheros,ath6kl";
+ atheros,board-id = "SD32";
+ };
+
+ gpio_keys {
+ compatible = "gpio-keys";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ irqbtn@pb18 {
+ label = "IRQBTN";
+ linux,code = <99>;
+ gpios = <&pioB 18 GPIO_ACTIVE_LOW>;
+ gpio-key,wakeup = <1>;
+ };
+ };
+};
projects / openwrt / staging / hauke.git / commitdiff