if (output & DPMS_USAGE)
ddk750_setDPMS((output & DPMS_MASK) >> DPMS_OFFSET);
}
-
-
-int ddk750_initDVIDisp(void)
-{
- /* Initialize DVI. If the dviInit fail and the VendorID or the DeviceID are
- not zeroed, then set the failure flag. If it is zeroe, it might mean
- that the system is in Dual CRT Monitor configuration. */
-
- /* De-skew enabled with default 111b value.
- This will fix some artifacts problem in some mode on board 2.2.
- Somehow this fix does not affect board 2.1.
- */
- if ((dviInit(1, /* Select Rising Edge */
- 1, /* Select 24-bit bus */
- 0, /* Select Single Edge clock */
- 1, /* Enable HSync as is */
- 1, /* Enable VSync as is */
- 1, /* Enable De-skew */
- 7, /* Set the de-skew setting to maximum setup */
- 1, /* Enable continuous Sync */
- 1, /* Enable PLL Filter */
- 4 /* Use the recommended value for PLL Filter value */
- ) != 0) && (dviGetVendorID() != 0x0000) && (dviGetDeviceID() != 0x0000)) {
- return (-1);
- }
-
- /* TODO: Initialize other display component */
-
- /* Success */
- return 0;
-
-}
-