ramips: OMNI-EMB-HPM.dts fixes

* add mdio-bus and phy nodes
* set phy-handle for the ethernet node
* define flash partiions
* cleanup flash node properties

Signed-off-by: Gabor Juhos <juhosg@openwrt.org>
SVN-Revision: 36273

diff --git a/target/linux/ramips/dts/OMNI-EMB-HPM.dts b/target/linux/ramips/dts/OMNI-EMB-HPM.dts
index f00c3820b4d4e1894cf65d673a1d9c11acf16e47..11cf0634e2404b4fc46826239716ed806e5ff36e 100644 (file)
--- a/target/linux/ramips/dts/OMNI-EMB-HPM.dts
+++ b/target/linux/ramips/dts/OMNI-EMB-HPM.dts
@@ -34,20 +34,52 @@
                        status = "okay";
 
                        m25p80@0 {
+                               compatible = "macronix,mx25l12805d";
+                               spi-max-frequency = <25000000>;
+                               reg = <0>;
+
                                #address-cells = <1>;
                                #size-cells = <1>;
-                               compatible = "mx25l6405d";
-                               reg = <0 0>;
-                               linux,modalias = "m25p80";
-                               spi-max-frequency = <25000000>;
+
+                               partition@0 {
+                                       reg = <0x0 0x0030000>;
+                                       label = "u-boot";
+                                       read-only;
+                               };
+
+                               partition@30000 {
+                                       reg = <0x00030000 0x00010000>;
+                                       label = "config";
+                                       read-only;
+                               };
+
+                               partition@40000 {
+                                       reg = <0x00040000 0x00010000>;
+                                       label = "factory";
+                                       read-only;
+                               };
+
+                               partition@50000 {
+                                       reg = <0x00050000 0x00fb0000>;
+                                       label = "firmware";
+                               };
                        };
                };
        };
 
        ethernet@10100000 {
                status = "okay";
-               ralink,phy-mask = <0x10>;
+
+               phy-handle = <&phy0>;
                phy-mode = "rgmii";
+
+               mdio-bus {
+                       status = "okay";
+
+                       phy0: ethernet-phy@4 {
+                               reg = <4>;
+                       };
+               };
        };
 
        wmac@10180000 {