Originally the Makefile defines CONFIG_ADS5121_REV2 when configuring
for board mpc5121ads_rev2. The config in include/configs/mpc5121ads.h
expects a define CONFIG_MPC5121ADS_REV2 for this.
Therefore there are two defines used but only 1 is defined.
This patch renames references to CONFIG_ADS5121_REV2 to CONFIG_MPC5121ADS_REV2
to have one common define.
This patch fixes faulty mem size detection caused by wrong config in
include/configs/mpc5121ads.h
Signed-off-by: Mark Vels <mark.vels@team-embedded.nl>
: unconfig
@mkdir -p $(obj)include
@if [ "$(findstring rev2,$@)" ] ; then \
- echo "#define CONFIG_ADS5121_REV2 1" > $(obj)include/config.h; \
+ echo "#define CONFIG_MPC5121ADS_REV2 1" > $(obj)include/config.h; \
fi
@$(MKCONFIG) -n $@ -a mpc5121ads powerpc mpc512x mpc5121ads freescale
* write commands in order to establish the device ID.
*/
-#ifdef CONFIG_ADS5121_REV2
+#ifdef CONFIG_MPC5121ADS_REV2
out_8((u8 *)(CONFIG_SYS_CPLD_BASE + 0x08), 0xC1);
#else
if (in_8((u8 *)(CONFIG_SYS_CPLD_BASE + 0x08)) & 0x04) {
volatile immap_t *im = (immap_t *) CONFIG_SYS_IMMR;
u32 spridr = in_be32(&im->sysconf.spridr);
- printf ("Board: ADS5121 rev. 0x%04x (CPLD rev. 0x%02x)\n",
+ printf ("Board: MPC5121ADS rev. 0x%04x (CPLD rev. 0x%02x)\n",
brd_rev, cpld_rev);
/* initialize function mux & slew rate IO inter alia on IO Pins */