lantiq: add FRITZ7360SL phy reset gpios

Due to a hardware bug of Atheros 8030 phys, the driver need to reset
the phys on link state change.

Use the correct compatible string for the at903x phys connected to
switch port 0 and 1.

Fix the pinmux of the gpio lines connected to the reset pin of the phys
and define the reset-pins to let the driver do the fixups.

Fixes FS#343

Signed-off-by: Mathias Kresin <dev@kresin.me>

diff --git a/target/linux/lantiq/dts/FRITZ7360SL.dts b/target/linux/lantiq/dts/FRITZ7360SL.dts
index b3cb1c52414733a81395b7ba7984874c86d20f56..0caea7fe711be82baba9e94bf866086d5b7f3852 100644 (file)
--- a/target/linux/lantiq/dts/FRITZ7360SL.dts
+++ b/target/linux/lantiq/dts/FRITZ7360SL.dts
@@ -70,7 +70,7 @@
                                };
                                phy-rst {
                                        lantiq,pins = "io37", "io44";
-                                       lantiq,pull = <2>;
+                                       lantiq,pull = <0>;
                                        lantiq,open-drain;
                                        lantiq,output = <1>;
                                };
@@ -160,14 +160,12 @@
                        reg = <0>;
                        phy-mode = "rmii";
                        phy-handle = <&phy0>;
-                       // gpios = <&gpio 37 GPIO_ACTIVE_LOW>;
                };
                ethernet@1 {
                        compatible = "lantiq,xrx200-pdi-port";
                        reg = <1>;
                        phy-mode = "rmii";
                        phy-handle = <&phy1>;
-                       // gpios = <&gpio 44 GPIO_ACTIVE_LOW>;
                };
                ethernet@2 {
                        compatible = "lantiq,xrx200-pdi-port";
@@ -189,11 +187,13 @@
                compatible = "lantiq,xrx200-mdio";
                phy0: ethernet-phy@0 {
                        reg = <0x00>;
-                       compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+                       compatible = "ethernet-phy-id004d.d076", "ethernet-phy-ieee802.3-c22";
+                       reset-gpios = <&gpio 37 GPIO_ACTIVE_LOW>;
                };
                phy1: ethernet-phy@1 {
                        reg = <0x01>;
-                       compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
+                       compatible = "ethernet-phy-id004d.d076", "ethernet-phy-ieee802.3-c22";
+                       reset-gpios = <&gpio 44 GPIO_ACTIVE_LOW>;
                };
                phy11: ethernet-phy@11 {
                        reg = <0x11>;