Indoor low-power router with 2.4 GHz radio
CPU: Atheros AR7241 rev 1
RAM: 32 MB
Flash: 8 MB NOR SPI
Switch: Atheros AR7240
Ports: 1x WAN, 4x LAN 10/100 Ethernet
WLAN: Atheros AR9285 (2.4 GHz)
USB: 1x USB2 host port
Note: Ethernet WAN/LAN port naming is reversed from ar71xx.
WAN is eth0; LAN is eth1.1.
UART settings: 115200, 8N1
LEDs
+--------------------------
|
|
|
|
|
|
|
|
VCC | x x
RX | * x
| x x
| x x
TX | * x
GND | * x
|
|
|
|
+--------------------------
ETHERNET PORTS
Installation from Ubiquiti firmware, is as for other ubnt-xm AirOs devices.
Signed-off-by: Russell Senior <russell@personaltelco.net>
buffalo,whr-g301n|\
tplink,tl-mr3220-v1|\
tplink,tl-mr3420-v1|\
- tplink,tl-wr841-v7)
+ tplink,tl-wr841-v7|\
+ ubnt,airrouter)
ucidef_set_interface_wan "eth0"
ucidef_add_switch "switch0" \
"0@eth1" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1"
tplink,tl-wr741-v1|\
tplink,tl-wr743nd-v1|\
tplink,tl-wr841-v7|\
+ ubnt,airrouter|\
ubnt,bullet-m|\
ubnt,nano-m|\
ubnt,rocket-m)
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar7241_ubnt_xm.dtsi"
+
+/ {
+ compatible = "ubnt,airrouter", "qca,ar7241";
+ model = "Ubiquiti AirRouter";
+
+ aliases {
+ led-boot = &globe;
+ led-failsafe = &globe;
+ led-running = &globe;
+ led-upgrade = &globe;
+ };
+
+ airrouter-leds {
+ compatible = "gpio-leds";
+
+ globe: globe {
+ label = "ubnt:green:globe";
+ gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
+ };
+
+ power {
+ label = "ubnt:green:power";
+ gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
+ };
+ };
+};
+
+&usb_phy {
+ status = "okay";
+};
+
+&usb {
+ status = "okay";
+};
ATH_SOC := ar9342
endef
+define Device/ubnt_airrouter
+ $(Device/ubnt-xm)
+ DEVICE_TITLE := Ubiquiti AirRouter
+ SUPPORTED_DEVICES += airrouter
+endef
+TARGET_DEVICES += ubnt_airrouter
+
define Device/ubnt_bullet-m
$(Device/ubnt-xm)
DEVICE_TITLE := Ubiquiti Bullet-M