# CONFIG_ARCH_AT91SAM9261 is not set
# CONFIG_ARCH_AT91SAM9263 is not set
# CONFIG_ARCH_AT91SAM9G10 is not set
-CONFIG_ARCH_AT91SAM9G20=y
+# CONFIG_ARCH_AT91SAM9G20 is not set
# CONFIG_ARCH_AT91SAM9G45 is not set
# CONFIG_ARCH_AT91SAM9RL is not set
# CONFIG_ARCH_AT91X40 is not set
unsigned pins;
/* Initialize processor: 18.432 MHz crystal */
- at91sam9263_initialize(18432000);
+ at91_initialize(18432000);
/* DGBU on ttyS0. (Rx & Tx only) */
at91_register_uart(0, 0, 0);
}
-static void __init tqma9263_init_irq(void)
-{
- at91sam9263_init_interrupts(NULL);
-}
-
-
/*
* USB Host port
*/
static struct at91_usbh_data __initdata tqma9263_usbh_data = {
.ports = 2,
.vbus_pin = { AT91_PIN_PA24, AT91_PIN_PA21 },
- .vbus_active_high = 1,
+ .vbus_pin_active_low = 0,
};
/*
* MACB Ethernet device
*/
-static struct at91_eth_data __initdata tqma9263_macb_data = {
+static struct macb_platform_data __initdata tqma9263_macb_data = {
.phy_irq_pin = AT91_PIN_PE31,
.is_rmii = 1,
};
.cle = 22,
.rdy_pin = AT91_PIN_PD14,
.enable_pin = AT91_PIN_PD15,
- .partition_info = nand_partitions,
};
static struct sam9_smc_config __initdata tqma9263_nand_smc_config = {
static void __init tqma9263_add_device_nand(void)
{
/* configure chip-select 3 (NAND) */
- sam9_smc_configure(3, &tqma9263_nand_smc_config);
+ sam9_smc_configure(0, 3, &tqma9263_nand_smc_config);
at91_add_device_nand(&tqma9263_nand_data);
}
MACHINE_START(TQMA9263, "TQ Components TQMa9263")
/* Maintainer: Michael Heimpold */
- .phys_io = AT91_BASE_SYS,
- .io_pg_offst = (AT91_VA_BASE_SYS >> 18) & 0xfffc,
- .boot_params = AT91_SDRAM_BASE + 0x100,
.timer = &at91sam926x_timer,
.map_io = tqma9263_map_io,
- .init_irq = tqma9263_init_irq,
+ .init_irq = at91_init_irq_default,
.init_machine = tqma9263_board_init,
MACHINE_END