There are several cases where phy-mode and status properties are
set again in DTS(I) files although those were set to the same values
in parent DTSI files already. Remove those cases (and thus also stop
their proliferation by copy/paste).
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
14 files changed:
resets = <&rst 9>;
reset-names = "mac";
- phy-mode = "mii";
phy-handle = <&swphy4>;
};
resets = <&rst 9>;
reset-names = "mac";
- phy-mode = "mii";
phy-handle = <&swphy4>;
};
ð0 {
status = "okay";
- phy-mode = "mii";
mtd-mac-address = <&uboot 0x1fc00>;
phy-handle = <&phy12>;
resets = <&rst 9>;
reset-names = "mac";
- phy-mode = "mii";
phy-handle = <&swphy4>;
};
interrupts = <2>;
};
-ð0 {
- phy-mode = "mii";
-};
-
ð1 {
status = "okay";
};
};
ð1 {
- status = "okay";
-
phy-handle = <&swphy4>;
- mtd-mac-address = <&art 0x0>;
- phy-mode = "gmii";
pll-data = <0x06000000 0x00000101 0x00001616>;
+ mtd-mac-address = <&art 0x0>;
+
gmac-config {
device = <&gmac>;
switch-phy-swap = <1>;
ð0 {
status = "okay";
- phy-mode = "mii";
phy-handle = <&phy0>;
gmac-config {
reset-names = "mac";
resets = <&rst 9>;
-
- phy-mode = "mii";
};
&mdio1 {
ð0 {
status = "okay";
- phy-mode = "mii";
phy-handle = <&swphy0>;
gmac-config {
ð0 {
status = "okay";
- phy-mode = "mii";
phy-handle = <&swphy4>;
mtd-mac-address = <&info 0x8>;
ð0 {
status = "okay";
- phy-mode = "mii";
phy-handle = <&swphy0>;
mtd-mac-address = <&mac 0x8>;
ð0 {
status = "okay";
- phy-mode = "mii";
phy-handle = <&swphy4>;
mtd-mac-address = <&mac 0x8>;
resets = <&rst 13>;
reset-names = "mac";
- status = "disabled";
-
fixed-link {
speed = <1000>;
full-duplex;
ð0 {
status = "okay";
- phy-mode = "mii";
phy-handle = <&swphy4>;
mtd-mac-address = <&uboot 0x1fc00>;