return IRQ_NONE;
- /* shared irq, not for us */
-+ if (test_bit(ATH_OP_HW_RESET, &common->op_flags))
++ if (!AR_SREV_9100(ah) && test_bit(ATH_OP_HW_RESET, &common->op_flags))
+ return IRQ_NONE;
+ /* shared irq, not for us */
/*
* Figure out the reason(s) for the interrupt. Note
* that the hal returns a pseudo-ISR that may include
-@@ -613,6 +610,7 @@ int ath_reset(struct ath_softc *sc, stru
+@@ -532,6 +529,9 @@ irqreturn_t ath_isr(int irq, void *dev)
+ ath9k_debug_sync_cause(sc, sync_cause);
+ status &= ah->imask; /* discard unasked-for bits */
+
++ if (AR_SREV_9100(ah) && test_bit(ATH_OP_HW_RESET, &common->op_flags))
++ return IRQ_HANDLED;
++
+ /*
+ * If there are no status bits set, then this interrupt was not
+ * for me (should have been caught above).
+@@ -613,6 +613,7 @@ int ath_reset(struct ath_softc *sc, stru
struct ath_common *common = ath9k_hw_common(sc->sc_ah);
int r;
set_bit(ATH_OP_HW_RESET, &common->op_flags);
ath9k_ps_wakeup(sc);
-@@ -633,6 +631,7 @@ void ath9k_queue_reset(struct ath_softc
+@@ -633,6 +634,7 @@ void ath9k_queue_reset(struct ath_softc
#ifdef CPTCFG_ATH9K_DEBUGFS
RESET_STAT_INC(sc, type);
#endif
CFG80211_TESTMODE_CMD(ieee80211_testmode_cmd)
--- a/net/mac80211/ieee80211_i.h
+++ b/net/mac80211/ieee80211_i.h
-@@ -1330,6 +1330,7 @@ struct ieee80211_local {
+@@ -1339,6 +1339,7 @@ struct ieee80211_local {
int dynamic_ps_forced_timeout;
int user_power_level; /* in dBm, for all interfaces */
REG_SET_BIT(ah, AR_BTCOEX_WL_LNADIV, AR_BTCOEX_WL_LNADIV_FORCE_ON);
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
-@@ -529,6 +529,11 @@ irqreturn_t ath_isr(int irq, void *dev)
- ath9k_debug_sync_cause(sc, sync_cause);
- status &= ah->imask; /* discard unasked-for bits */
+@@ -532,6 +532,11 @@ irqreturn_t ath_isr(int irq, void *dev)
+ if (AR_SREV_9100(ah) && test_bit(ATH_OP_HW_RESET, &common->op_flags))
+ return IRQ_HANDLED;
+ if (test_bit(ATH_DIAG_TRIGGER_ERROR, &ah->diag)) {
+ status |= ATH9K_INT_FATAL;