This was introduced in:
commit
7c4a395ff8f441acb7876281c6777624e6410349
Author: Ville Syrjälä <ville.syrjala@linux.intel.com>
Date: Wed Oct 9 19:17:56 2013 +0300
drm/i915: Don't re-compute pipe watermarks except for the affected pipe
and I missed fixing it in:
commit
fec8cba306f974f3a4491176994de5d821273643
Author: Jesse Barnes <jbarnes@virtuousgeek.org>
Date: Wed Nov 27 11:10:26 2013 -0800
drm/i915: use crtc_htotal in watermark calculations to match fastboot v2
It's needed for ILK+ platforms to fastboot without crashing on a divide
by 0 after a DPMS on action.
Note: Ville mentioned in his review that this confusion seems to go
down to the original introduction of this code in
commit
801bcfffbb0721d7131e930f9a46103e539c43a4
Author: Paulo Zanoni <paulo.r.zanoni@intel.com>
Date: Fri May 31 10:08:35 2013 -0300
drm/i915: properly set HSW WM_PIPE registers
So it seems to have been missed both in the fastboot patch and in the
3d mode suppport (where only crtc_htotal reflects the real pipe
width).
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Reviewed-by: Ville Syrjälä <ville.syrjala@linux.intel.com>
[danvet: Add note based on Ville's review.]
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
p->active = intel_crtc_active(crtc);
if (p->active) {
- p->pipe_htotal = intel_crtc->config.adjusted_mode.htotal;
+ p->pipe_htotal = intel_crtc->config.adjusted_mode.crtc_htotal;
p->pixel_rate = ilk_pipe_pixel_rate(dev, crtc);
p->pri.bytes_per_pixel = crtc->fb->bits_per_pixel / 8;
p->cur.bytes_per_pixel = 4;