/* Configure Tx antenna selection based on H/W config */
iwlagn_send_tx_ant_config(priv, priv->cfg->valid_tx_ant);
- if (iwl_is_associated_ctx(ctx) && !priv->wowlan) {
+ if (iwl_is_associated_ctx(ctx) && !priv->shrd->wowlan) {
struct iwl_rxon_cmd *active_rxon =
(struct iwl_rxon_cmd *)&ctx->active;
/* apply any changes in staging */
iwlagn_set_rxon_chain(priv, ctx);
}
- if (!priv->wowlan) {
+ if (!priv->shrd->wowlan) {
/* WoWLAN ucode will not reply in the same way, skip it */
iwl_reset_run_time_calib(priv);
}
iwl_trans_stop_device(trans(priv));
- priv->wowlan = true;
+ priv->shrd->wowlan = true;
ret = iwlagn_load_ucode_wait_alive(priv, &priv->ucode_wowlan,
IWL_UCODE_WOWLAN);
goto out;
error:
- priv->wowlan = false;
+ priv->shrd->wowlan = false;
iwlagn_prepare_restart(priv);
ieee80211_restart_hw(priv->hw);
out:
/* we'll clear ctx->vif during iwlagn_prepare_restart() */
vif = ctx->vif;
- priv->wowlan = false;
+ priv->shrd->wowlan = false;
device_set_wakeup_enable(priv->bus->dev, false);
return cpu_to_le32(res);
}
-#ifdef CONFIG_PM
-
-int iwl_suspend(struct iwl_priv *priv)
-{
- /*
- * This function is called when system goes into suspend state
- * mac80211 will call iwl_mac_stop() from the mac80211 suspend function
- * first but since iwl_mac_stop() has no knowledge of who the caller is,
- * it will not call apm_ops.stop() to stop the DMA operation.
- * Calling apm_ops.stop here to make sure we stop the DMA.
- *
- * But of course ... if we have configured WoWLAN then we did other
- * things already :-)
- */
- if (!priv->wowlan)
- iwl_apm_stop(priv);
-
- return 0;
-}
-
-int iwl_resume(struct iwl_priv *priv)
-{
- bool hw_rfkill = false;
-
- iwl_enable_interrupts(priv);
-
- if (!(iwl_read32(priv, CSR_GP_CNTRL) &
- CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW))
- hw_rfkill = true;
-
- if (hw_rfkill)
- set_bit(STATUS_RF_KILL_HW, &priv->shrd->status);
- else
- clear_bit(STATUS_RF_KILL_HW, &priv->shrd->status);
-
- wiphy_rfkill_set_hw_state(priv->hw->wiphy, hw_rfkill);
-
- return 0;
-}
-
-#endif /* CONFIG_PM */
u8 mac80211_registered;
- bool wowlan;
-
/* eeprom -- this is in the card's little endian byte order */
u8 *eeprom;
int nvm_device_type;
* WoWLAN is enabled - don't kill the NIC, someone may need it in Sx.
*/
- return iwl_suspend(shrd->priv);
+ return iwl_trans_suspend(shrd->trans);
}
static int iwl_pci_resume(struct device *device)
*/
pci_write_config_byte(pdev, PCI_CFG_RETRY_TIMEOUT, 0x00);
- return iwl_resume(shrd->priv);
+ return iwl_trans_resume(shrd->trans);
}
static SIMPLE_DEV_PM_OPS(iwl_dev_pm_ops, iwl_pci_suspend, iwl_pci_resume);
dtimper = priv->hw->conf.ps_dtim_period ?: 1;
- if (priv->wowlan)
+ if (priv->shrd->wowlan)
iwl_static_sleep_cmd(priv, cmd, IWL_POWER_INDEX_5, dtimper);
else if (!priv->cfg->base_params->no_idle_support &&
priv->hw->conf.flags & IEEE80211_CONF_IDLE)
u8 cmd_queue;
unsigned long status;
+ bool wowlan;
struct iwl_bus *bus;
struct iwl_priv *priv;
trans(priv) = NULL;
}
+#ifdef CONFIG_PM
+
+static int iwl_trans_pcie_suspend(struct iwl_trans *trans)
+{
+ /*
+ * This function is called when system goes into suspend state
+ * mac80211 will call iwl_mac_stop() from the mac80211 suspend function
+ * first but since iwl_mac_stop() has no knowledge of who the caller is,
+ * it will not call apm_ops.stop() to stop the DMA operation.
+ * Calling apm_ops.stop here to make sure we stop the DMA.
+ *
+ * But of course ... if we have configured WoWLAN then we did other
+ * things already :-)
+ */
+ if (!trans->shrd->wowlan)
+ iwl_apm_stop(priv(trans));
+
+ return 0;
+}
+
+static int iwl_trans_pcie_resume(struct iwl_trans *trans)
+{
+ bool hw_rfkill = false;
+
+ iwl_enable_interrupts(priv(trans));
+
+ if (!(iwl_read32(priv(trans), CSR_GP_CNTRL) &
+ CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW))
+ hw_rfkill = true;
+
+ if (hw_rfkill)
+ set_bit(STATUS_RF_KILL_HW, &trans->shrd->status);
+ else
+ clear_bit(STATUS_RF_KILL_HW, &trans->shrd->status);
+
+ wiphy_rfkill_set_hw_state(priv(trans)->hw->wiphy, hw_rfkill);
+
+ return 0;
+}
+#else /* CONFIG_PM */
+static int iwl_trans_pcie_suspend(struct iwl_trans *trans)
+{ return 0; }
+
+static int iwl_trans_pcie_resume(struct iwl_trans *trans)
+{ return 0; }
+
+#endif /* CONFIG_PM */
+
const struct iwl_trans_ops trans_ops_pcie;
static struct iwl_trans *iwl_trans_pcie_alloc(struct iwl_shared *shrd)
.free = iwl_trans_pcie_free,
.dbgfs_register = iwl_trans_pcie_dbgfs_register,
+ .suspend = iwl_trans_pcie_suspend,
+ .resume = iwl_trans_pcie_resume,
};
* irq, tasklet etc...
* @dbgfs_register: add the dbgfs files under this directory. Files will be
* automatically deleted.
+ * @suspend: stop the device unless WoWLAN is configured
+ * @resume: resume activity of the device
*/
struct iwl_trans_ops {
void (*free)(struct iwl_priv *priv);
int (*dbgfs_register)(struct iwl_trans *trans, struct dentry* dir);
+ int (*suspend)(struct iwl_trans *trans);
+ int (*resume)(struct iwl_trans *trans);
};
/**
return trans->ops->dbgfs_register(trans, dir);
}
+static inline int iwl_trans_suspend(struct iwl_trans *trans)
+{
+ return trans->ops->suspend(trans);
+}
+
+static inline int iwl_trans_resume(struct iwl_trans *trans)
+{
+ return trans->ops->resume(trans);
+}
+
/*****************************************************
* Transport layers implementations
******************************************************/