ide: remove ide-tape documentation from Documentation/ide.txt

More complete documentation is available in Documentation/ide/ide-tape.txt.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

diff --git a/Documentation/ide.txt b/Documentation/ide.txt
index 7b782e84001fae951c779fb633812aa3fdb9b81a..bcd7cd1278efd285d456fe058d1774b5181d5a7b 100644 (file)
--- a/Documentation/ide.txt
+++ b/Documentation/ide.txt
@@ -305,53 +305,6 @@ Also for legacy CMD640 host driver (cmd640) you need to use "probe_vlb"
 kernel paremeter to enable probing for VLB version of the chipset (PCI ones
 are detected automatically).
 
-================================================================================
-
-IDE ATAPI streaming tape driver
--------------------------------
-
-This driver is a part of the Linux ide driver and works in co-operation
-with linux/drivers/block/ide.c.
-
-The driver, in co-operation with ide.c, basically traverses the
-request-list for the block device interface. The character device
-interface, on the other hand, creates new requests, adds them
-to the request-list of the block device, and waits for their completion.
-
-Pipelined operation mode is now supported on both reads and writes.
-
-The block device major and minor numbers are determined from the
-tape's relative position in the ide interfaces, as explained in ide.c.
-
-The character device interface consists of the following devices:
-
- ht0           major 37, minor 0       first  IDE tape, rewind on close.
- ht1           major 37, minor 1       second IDE tape, rewind on close.
- ...
- nht0          major 37, minor 128     first  IDE tape, no rewind on close.
- nht1          major 37, minor 129     second IDE tape, no rewind on close.
- ...
-
-Run /dev/MAKEDEV to create the above entries.
-
-The general magnetic tape commands compatible interface, as defined by
-include/linux/mtio.h, is accessible through the character device.
-
-General ide driver configuration options, such as the interrupt-unmask
-flag, can be configured by issuing an ioctl to the block device interface,
-as any other ide device.
-
-Our own ide-tape ioctl's can be issued to either the block device or
-the character device interface.
-
-Maximal throughput with minimal bus load will usually be achieved in the
-following scenario:
-
-       1.      ide-tape is operating in the pipelined operation mode.
-       2.      No buffering is performed by the user backup program.
-
-
-
 ================================================================================
 
 Some Terminology