usb: phy: msm: Do not do runtime pm if the phy is not idle

Use case is when the phy is configured in host mode and a usb device is
attached to board before bootup. On bootup, with the existing code and
runtime pm enabled, the driver would decrement the pm usage count
without checking the current state of the phy. This pm usage count
decrement would trigger the runtime pm which than would abort the
usb enumeration which was in progress. In my case a usb stick gets
detected and then immediatly the driver goes to low power mode which is
not correct.

log:
[    1.631412] msm_hsusb_host 12520000.usb: EHCI Host Controller
[    1.636556] msm_hsusb_host 12520000.usb: new USB bus registered, assigned bus number 1
[    1.642563] msm_hsusb_host 12520000.usb: irq 220, io mem 0x12520000
[    1.658197] msm_hsusb_host 12520000.usb: USB 2.0 started, EHCI 1.00
[    1.659473] hub 1-0:1.0: USB hub found
[    1.663415] hub 1-0:1.0: 1 port detected
...
[    1.973352] usb 1-1: new high-speed USB device number 2 using msm_hsusb_host
[    2.107707] usb-storage 1-1:1.0: USB Mass Storage device detected
[    2.108993] scsi0 : usb-storage 1-1:1.0
[    2.678341] msm_otg 12520000.phy: USB in low power mode
[    3.168977] usb 1-1: USB disconnect, device number 2

This issue was detected on IFC6410 board.

This patch fixes the intial runtime pm trigger by checking the phy
state and decrementing the pm use count only when the phy state is IDLE.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Felipe Balbi <balbi@ti.com>

diff --git a/drivers/usb/phy/phy-msm-usb.c b/drivers/usb/phy/phy-msm-usb.c
index ced34f39bdd47f29ddf308ad7d89f59af3e5b3ce..c929370cdaa64454201d7b2a1884f0d88f3c87a8 100644 (file)
--- a/drivers/usb/phy/phy-msm-usb.c
+++ b/drivers/usb/phy/phy-msm-usb.c
@@ -1229,7 +1229,9 @@ static void msm_otg_sm_work(struct work_struct *w)
                        motg->chg_state = USB_CHG_STATE_UNDEFINED;
                        motg->chg_type = USB_INVALID_CHARGER;
                }
-               pm_runtime_put_sync(otg->phy->dev);
+
+               if (otg->phy->state == OTG_STATE_B_IDLE)
+                       pm_runtime_put_sync(otg->phy->dev);
                break;
        case OTG_STATE_B_PERIPHERAL:
                dev_dbg(otg->phy->dev, "OTG_STATE_B_PERIPHERAL state\n");