firewire: get_cycle_timer optimization and cleanup

ohci:  Break out of the retry loop if too many attempts were necessary.
This may theoretically happen if the chip is fatally defective or if the
get_cycle_timer ioctl was performed after a CardBus controller was
ejected.

Also micro-optimize the loop by re-using the last two register reads in
the next iteration, remove a questionable inline keyword, and shuffle a
comment around.

core:  ioctl_get_cycle_timer() is always called with interrupts on,
therefore local_irq_save() can be replaced by local_irq_disable().
Disabled local IRQs imply disabled preemption, hence preempt_disable()
can be removed.

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

diff --git a/drivers/firewire/core-cdev.c b/drivers/firewire/core-cdev.c
index e6d63849e78ee44302e436c26f871e5b3dd3eef7..ecd0a4d81abf07355ddb14f88597075e76d8184f 100644 (file)
--- a/drivers/firewire/core-cdev.c
+++ b/drivers/firewire/core-cdev.c
@@ -25,6 +25,7 @@
 #include <linux/firewire.h>
 #include <linux/firewire-cdev.h>
 #include <linux/idr.h>
+#include <linux/irqflags.h>
 #include <linux/jiffies.h>
 #include <linux/kernel.h>
 #include <linux/kref.h>
@@ -32,7 +33,6 @@
 #include <linux/module.h>
 #include <linux/mutex.h>
 #include <linux/poll.h>
-#include <linux/preempt.h>
 #include <linux/sched.h>
 #include <linux/spinlock.h>
 #include <linux/time.h>
@@ -1013,21 +1013,19 @@ static int ioctl_get_cycle_timer(struct client *client, void *buffer)
 {
        struct fw_cdev_get_cycle_timer *request = buffer;
        struct fw_card *card = client->device->card;
-       unsigned long long bus_time;
        struct timeval tv;
-       unsigned long flags;
+       u32 cycle_time;
 
-       preempt_disable();
-       local_irq_save(flags);
+       local_irq_disable();
 
-       bus_time = card->driver->get_bus_time(card);
+       cycle_time = card->driver->get_bus_time(card);
        do_gettimeofday(&tv);
 
-       local_irq_restore(flags);
-       preempt_enable();
+       local_irq_enable();
 
        request->local_time = tv.tv_sec * 1000000ULL + tv.tv_usec;
-       request->cycle_timer = bus_time & 0xffffffff;
+       request->cycle_timer = cycle_time;
+
        return 0;
 }
 

diff --git a/drivers/firewire/ohci.c b/drivers/firewire/ohci.c
index bf5e112844210a2aa8c08b4d8754036853e363c1..c3eb471d22f7e867e542fabb5e5ef0c46df2a506 100644 (file)
--- a/drivers/firewire/ohci.c
+++ b/drivers/firewire/ohci.c
@@ -1795,60 +1795,61 @@ static int ohci_enable_phys_dma(struct fw_card *card,
 #endif /* CONFIG_FIREWIRE_OHCI_REMOTE_DMA */
 }
 
-static inline u32 cycle_timer_ticks(u32 cycle_timer)
+static u32 cycle_timer_ticks(u32 cycle_timer)
 {
        u32 ticks;
 
        ticks = cycle_timer & 0xfff;
        ticks += 3072 * ((cycle_timer >> 12) & 0x1fff);
        ticks += (3072 * 8000) * (cycle_timer >> 25);
+
        return ticks;
 }
 
+/*
+ * Some controllers exhibit one or more of the following bugs when updating the
+ * iso cycle timer register:
+ *  - When the lowest six bits are wrapping around to zero, a read that happens
+ *    at the same time will return garbage in the lowest ten bits.
+ *  - When the cycleOffset field wraps around to zero, the cycleCount field is
+ *    not incremented for about 60 ns.
+ *  - Occasionally, the entire register reads zero.
+ *
+ * To catch these, we read the register three times and ensure that the
+ * difference between each two consecutive reads is approximately the same, i.e.
+ * less than twice the other.  Furthermore, any negative difference indicates an
+ * error.  (A PCI read should take at least 20 ticks of the 24.576 MHz timer to
+ * execute, so we have enough precision to compute the ratio of the differences.)
+ */
 static u64 ohci_get_bus_time(struct fw_card *card)
 {
        struct fw_ohci *ohci = fw_ohci(card);
        u32 c0, c1, c2;
        u32 t0, t1, t2;
        s32 diff01, diff12;
-       u64 bus_time;
+       int i;
 
-       if (!ohci->iso_cycle_timer_quirk) {
+       c2 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
+
+       if (ohci->iso_cycle_timer_quirk) {
+               i = 0;
+               c1 = c2;
                c2 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
-       } else {
-               /*
-                * Some controllers exhibit one or more of the following bugs
-                * when updating the iso cycle timer register:
-                *  - When the lowest six bits are wrapping around to zero,
-                *    a read that happens at the same time will return garbage
-                *    in the lowest ten bits.
-                *  - When the cycleOffset field wraps around to zero, the
-                *    cycleCount field is not incremented for about 60 ns.
-                *  - Occasionally, the entire register reads zero.
-                *
-                * To catch these, we read the register three times and ensure
-                * that the difference between each two consecutive reads is
-                * approximately the same, i.e., less than twice the other.
-                * Furthermore, any negative difference indicates an error.
-                * (A PCI read should take at least 20 ticks of the 24.576 MHz
-                * timer to execute, so we have enough precision to compute the
-                * ratio of the differences.)
-                */
                do {
-                       c0 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
-                       c1 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
+                       c0 = c1;
+                       c1 = c2;
                        c2 = reg_read(ohci, OHCI1394_IsochronousCycleTimer);
                        t0 = cycle_timer_ticks(c0);
                        t1 = cycle_timer_ticks(c1);
                        t2 = cycle_timer_ticks(c2);
                        diff01 = t1 - t0;
                        diff12 = t2 - t1;
-               } while (diff01 <= 0 || diff12 <= 0 ||
-                        diff01 / diff12 >= 2 || diff12 / diff01 >= 2);
+               } while ((diff01 <= 0 || diff12 <= 0 ||
+                         diff01 / diff12 >= 2 || diff12 / diff01 >= 2)
+                        && i++ < 20);
        }
-       bus_time = ((u64)atomic_read(&ohci->bus_seconds) << 32) | c2;
 
-       return bus_time;
+       return ((u64)atomic_read(&ohci->bus_seconds) << 32) | c2;
 }
 
 static void copy_iso_headers(struct iso_context *ctx, void *p)