* @IWL_UCODE_TLV_FLAGS_UAPSD: This uCode image supports uAPSD
* @IWL_UCODE_TLV_FLAGS_SHORT_BL: 16 entries of black list instead of 64 in scan
* offload profile config command.
- * @IWL_UCODE_TLV_FLAGS_RX_ENERGY_API: supports rx signal strength api
* @IWL_UCODE_TLV_FLAGS_TIME_EVENT_API_V2: using the new time event API.
* @IWL_UCODE_TLV_FLAGS_D3_6_IPV6_ADDRS: D3 image supports up to six
* (rather than two) IPv6 addresses
IWL_UCODE_TLV_FLAGS_P2P = BIT(3),
IWL_UCODE_TLV_FLAGS_DW_BC_TABLE = BIT(4),
IWL_UCODE_TLV_FLAGS_SHORT_BL = BIT(7),
- IWL_UCODE_TLV_FLAGS_RX_ENERGY_API = BIT(8),
IWL_UCODE_TLV_FLAGS_TIME_EVENT_API_V2 = BIT(9),
IWL_UCODE_TLV_FLAGS_D3_6_IPV6_ADDRS = BIT(10),
IWL_UCODE_TLV_FLAGS_BF_UPDATED = BIT(11),
ieee80211_rx(mvm->hw, skb);
}
-static void iwl_mvm_calc_rssi(struct iwl_mvm *mvm,
- struct iwl_rx_phy_info *phy_info,
- struct ieee80211_rx_status *rx_status)
-{
- int rssi_a, rssi_b, rssi_a_dbm, rssi_b_dbm, max_rssi_dbm;
- u32 agc_a, agc_b;
- u32 val;
-
- val = le32_to_cpu(phy_info->non_cfg_phy[IWL_RX_INFO_AGC_IDX]);
- agc_a = (val & IWL_OFDM_AGC_A_MSK) >> IWL_OFDM_AGC_A_POS;
- agc_b = (val & IWL_OFDM_AGC_B_MSK) >> IWL_OFDM_AGC_B_POS;
-
- val = le32_to_cpu(phy_info->non_cfg_phy[IWL_RX_INFO_RSSI_AB_IDX]);
- rssi_a = (val & IWL_OFDM_RSSI_INBAND_A_MSK) >> IWL_OFDM_RSSI_A_POS;
- rssi_b = (val & IWL_OFDM_RSSI_INBAND_B_MSK) >> IWL_OFDM_RSSI_B_POS;
-
- /*
- * dBm = rssi dB - agc dB - constant.
- * Higher AGC (higher radio gain) means lower signal.
- */
- rssi_a_dbm = rssi_a - IWL_RSSI_OFFSET - agc_a;
- rssi_b_dbm = rssi_b - IWL_RSSI_OFFSET - agc_b;
- max_rssi_dbm = max_t(int, rssi_a_dbm, rssi_b_dbm);
-
- IWL_DEBUG_STATS(mvm, "Rssi In A %d B %d Max %d AGCA %d AGCB %d\n",
- rssi_a_dbm, rssi_b_dbm, max_rssi_dbm, agc_a, agc_b);
-
- rx_status->signal = max_rssi_dbm;
- rx_status->chains = (le16_to_cpu(phy_info->phy_flags) &
- RX_RES_PHY_FLAGS_ANTENNA)
- >> RX_RES_PHY_FLAGS_ANTENNA_POS;
- rx_status->chain_signal[0] = rssi_a_dbm;
- rx_status->chain_signal[1] = rssi_b_dbm;
-}
-
/*
* iwl_mvm_get_signal_strength - use new rx PHY INFO API
* values are reported by the fw as positive values - need to negate
*/
/*rx_status.flag |= RX_FLAG_MACTIME_MPDU;*/
- if (mvm->fw->ucode_capa.flags & IWL_UCODE_TLV_FLAGS_RX_ENERGY_API)
- iwl_mvm_get_signal_strength(mvm, phy_info, &rx_status);
- else
- iwl_mvm_calc_rssi(mvm, phy_info, &rx_status);
+ iwl_mvm_get_signal_strength(mvm, phy_info, &rx_status);
IWL_DEBUG_STATS_LIMIT(mvm, "Rssi %d, TSF %llu\n", rx_status.signal,
(unsigned long long)rx_status.mactime);