While converting Nanostation M XW from current ar71xx code to ath79 I've
hit one issue, where the ethernet networking wasn't working, so I was
checking every bit in the networking setup path between ar71xx and
ath79.
I've came to the following code in ar71xx/mach-ubnt-xm.c:
static void __init ubnt_xw_init(void) {
...
ath79_setup_ar934x_eth_cfg(AR934X_ETH_CFG_MII_GMAC0 |
AR934X_ETH_CFG_MII_GMAC0_SLAVE);
...
}
Where this code is setting AR934X_ETH_CFG_MII_GMAC0_SLAVE bit in
AR934X_GMAC_REG_ETH_CFG register, but I couldn't find a way of setting
this bit from DTS, so this patch adds `mii-gmac0-slave` DTS property
which allows setting of this bit in `gmac-config`, which is then used in
Nanostation M XW DTS.
Tested-by: Joe Ayers <ae6xe@arrl.net>
Signed-off-by: Petr Štetiar <ynezz@true.cz>
ag71xx_of_bit(np, "rgmii-gmac0", &val, AR934X_ETH_CFG_RGMII_GMAC0);
ag71xx_of_bit(np, "mii-gmac0", &val, AR934X_ETH_CFG_MII_GMAC0);
+ ag71xx_of_bit(np, "mii-gmac0-slave", &val, AR934X_ETH_CFG_MII_GMAC0_SLAVE);
ag71xx_of_bit(np, "gmii-gmac0", &val, AR934X_ETH_CFG_GMII_GMAC0);
ag71xx_of_bit(np, "switch-phy-swap", &val, AR934X_ETH_CFG_SW_PHY_SWAP);
ag71xx_of_bit(np, "switch-only-mode", &val,