Port device support for DAP-1330 from the ar71xx target to ath79.
Additionally, images are generated for the European through-socket
case variant DAP-1365. Both devices run the same vendor firmware, the
only difference being the DAP_SIGNATURE field in the factory header.
The vendor's Web UI will display a model string stored in the flash.
Specifications:
* QCA9533, 8 MiB Flash, 64 MiB RAM
* One Ethernet Port (10/100)
* Wall-plug style case (DAP-1365 with additional socket)
* LED bargraph RSSI indicator
Installation:
* Web UI: http://192.168.0.50 (or different address obtained via DHCP)
There is no password set by default
* Recovery Web UI: Keep reset button pressed during power-on
until LED starts flashing red, upgrade via http://192.168.0.50
* Some modern browsers may have problems flashing via the Web UI,
if this occurs consider booting to recovery mode and flashing via:
curl -F \
files=@openwrt-ath79-generic-dlink_dap-1330-a1-squashfs-factory.bin \
http://192.168.0.50/cgi/index
The device will use the same MAC address for both wired and wireless
interfaces, however it is stored at two different locations in the flash.
Signed-off-by: Sebastian Schaper <openwrt@sebastianschaper.net>
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "qca9533_dlink_dap-13xx.dtsi"
+
+/ {
+ compatible = "dlink,dap-1330-a1", "qca,qca9533";
+ model = "D-Link DAP-1330 A1";
+};
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "qca9533_dlink_dap-13xx.dtsi"
+
+/ {
+ compatible = "dlink,dap-1365-a1", "qca,qca9533";
+ model = "D-Link DAP-1365 A1";
+};
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca953x.dtsi"
+
+/ {
+ aliases {
+ led-boot = &led_power;
+ led-failsafe = &led_status;
+ led-running = &led_power;
+ led-upgrade = &led_status;
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ wps {
+ label = "wps";
+ linux,code = <KEY_WPS_BUTTON>;
+ gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
+ };
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_power: power {
+ label = "d-link:green:power";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ };
+
+ led_status: status {
+ label = "d-link:red:status";
+ gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
+ };
+
+ rssilow {
+ label = "d-link:red:rssilow";
+ gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+ };
+
+ rssimediumlow {
+ label = "d-link:green:rssimediumlow";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ };
+
+ rssimediumhigh {
+ label = "d-link:green:rssimediumhigh";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ };
+
+ rssihigh {
+ label = "d-link:green:rssihigh";
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+ };
+};
+
+&spi {
+ status = "okay";
+
+ num-cs = <1>;
+
+ flash@0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <50000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition@0 {
+ label = "u-boot";
+ reg = <0x0 0x10000>;
+ read-only;
+ };
+
+ art: partition@10000 {
+ label = "art";
+ reg = <0x10000 0x10000>;
+ read-only;
+ };
+
+ partition@20000 {
+ label = "mp";
+ reg = <0x20000 0x10000>;
+ read-only;
+ };
+
+ partition@30000 {
+ label = "config";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ partition@40000 {
+ label = "firmware";
+ reg = <0x40000 0x7c0000>;
+ compatible = "denx,uimage";
+ };
+ };
+ };
+};
+
+&uart {
+ status = "okay";
+};
+
+ð0 {
+ status = "okay";
+};
+
+&wmac {
+ status = "okay";
+
+ mtd-cal-data = <&art 0x1000>;
+};
devolo,magic-2-wifi)
ucidef_set_led_netdev "plcw" "dLAN" "devolo:white:dlan" "eth0.1" "rx"
;;
+dlink,dap-1330-a1|\
+dlink,dap-1365-a1)
+ ucidef_set_rssimon "wlan0" "200000" "1"
+ ucidef_set_led_rssi "rssilow" "RSSILOW" "d-link:red:rssilow" "wlan0" "1" "25"
+ ucidef_set_led_rssi "rssimediumlow" "RSSIMEDIUMLOW" "d-link:green:rssimediumlow" "wlan0" "1" "100"
+ ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" "d-link:green:rssimediumhigh" "wlan0" "51" "100"
+ ucidef_set_led_rssi "rssihigh" "RSSIHIGH" "d-link:green:rssihigh" "wlan0" "76" "100"
+ ;;
dlink,dir-859-a1)
ucidef_set_led_switch "internet" "WAN" "$boardname:green:internet" "switch0" "0x20"
;;
devolo,dvl1750c|\
devolo,dvl1750i|\
devolo,dvl1750x|\
+ dlink,dap-1330-a1|\
+ dlink,dap-1365-a1|\
dlink,dir-505|\
engenius,ecb1750|\
enterasys,ws-ap3705i|\
devolo,magic-2-wifi)
label_mac=$(macaddr_add "$(mtd_get_mac_binary art 0x1002)" 3)
;;
- dlink,dap-2695-a1)
- label_mac=$(mtd_get_mac_ascii bdcfg "wlanmac")
- ;;
+ dlink,dap-1330-a1|\
+ dlink,dap-1365-a1|\
dlink,dch-g020-a1)
lan_mac=$(mtd_get_mac_text "mp" 0x1)
label_mac=$lan_mac
;;
+ dlink,dap-2695-a1)
+ label_mac=$(mtd_get_mac_ascii bdcfg "wlanmac")
+ ;;
dlink,dir-825-b1)
lan_mac=$(mtd_get_mac_text "caldata" 0xffa0)
wan_mac=$(mtd_get_mac_text "caldata" 0xffb4)
adtran,bsap1840)
macaddr_add "$(mtd_get_mac_binary 'Board data' 2)" $(($PHYNBR * 8 + 1)) > /sys${DEVPATH}/macaddress
;;
+ dlink,dap-1330-a1|\
+ dlink,dap-1365-a1|\
dlink,dch-g020-a1)
mtd_get_mac_text "mp" 0x13 > /sys${DEVPATH}/macaddress
;;
arduino,yun)
migrate_leds "arduino:=yun:"
;;
+dlink,dap-1330-a1)
+ migrate_leds ":red:power=:red:status" \
+ ":red:wifi=:red:rssilow" \
+ ":green:wifi=:green:rssimediumlow" \
+ ":green:signal1=:green:rssimediumhigh" \
+ ":green:signal2=:green:rssihigh"
+ ;;
engenius,epg5000)
migrate_leds ":wlan-2g=:wlan2g" ":wlan-5g=:wlan5g"
;;
endef
TARGET_DEVICES += devolo_magic-2-wifi
+define Device/dlink_dap-13xx
+ SOC := qca9533
+ DEVICE_VENDOR := D-Link
+ DEVICE_PACKAGES += rssileds
+ IMAGE_SIZE := 7936k
+ IMAGES += factory.bin
+ IMAGE/factory.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | \
+ append-rootfs | pad-rootfs | check-size | mkdapimg2 0xE0000
+endef
+
+define Device/dlink_dap-1330-a1
+ $(Device/dlink_dap-13xx)
+ DEVICE_MODEL := DAP-1330
+ DEVICE_VARIANT := A1
+ DAP_SIGNATURE := HONEYBEE-FIRMWARE-DAP-1330
+ SUPPORTED_DEVICES += dap-1330-a1
+endef
+TARGET_DEVICES += dlink_dap-1330-a1
+
+define Device/dlink_dap-1365-a1
+ $(Device/dlink_dap-13xx)
+ DEVICE_MODEL := DAP-1365
+ DEVICE_VARIANT := A1
+ DAP_SIGNATURE := HONEYBEE-FIRMWARE-DAP-1365
+endef
+TARGET_DEVICES += dlink_dap-1365-a1
+
define Device/dlink_dap-2695-a1
SOC := qca9558
DEVICE_PACKAGES := ath10k-firmware-qca988x-ct kmod-ath10k-ct