Merge branch 'cpsw-mq'

Ivan Khoronzhuk says:

====================
net: ethernet: ti: cpsw: add cpdma multi-queue support

This series is intended to allow cpsw driver to use cpdma ability of
h/w shaper to send/receive data with up to 8 tx and 8 rx queues. This
series doesn't contain interface to configure h/w shaper itself, it
contains only multi-queue support part and ability to configure number
of tx/rx queues with ethtool, it also doesn't contain mapping of input
traffic to rx queues, as it can depend on usage and requires separate
interface for setup.

Default shaper mode - priority mode. The h/w shaper configuration will
be added with separate patch series. This series doesn't affect on net
throughput.

Tested on:
am572x-idk, 1Gbps link
am335-boneblack, 100Mbps link.

A simple example for splitting traffic on queues:

$ ethtool -l eth0

$ ethtool -L eth0 rx 8 tx 8

$ tc qdisc add dev eth0 root handle 1: multiq

$ tc filter add dev eth0 parent 1: protocol ip prio 1 u32 \
    match ip dst 172.22.39.12 \
    action skbedit queue_mapping 5

Based on: net-next/master
V3: https://lkml.org/lkml/2016/8/15/788

Since v3:
-changed arg to priv in fill_rx_channels in
  net: ethernet: ti: davinci_cpdma: split descs num between all channels
- added more comments to cpsw_set_channels

Since v2:
- added new patch to avoid warn while ctrl stop

  net: ethernet: ti: cpsw: add ethtool channels support
- enable ctrl in case at least one interface is running

Since v1:
- removed cpdam_check_free_desc function
- remove pm_runtime calls as they are used in begin/complete ethtool calls now
- removed change of driver version. it can be done later
- corrected setup of channels for dual_emac mode with ethtool
====================

Signed-off-by: David S. Miller <davem@davemloft.net>