Device specifications:
* Qualcomm/Atheros QCA9533 v2
* 650/600/217 MHz (CPU/DDR/AHB)
* 64 MB of RAM
* 16 MB of SPI NOR flash (mx25l12805d)
- 2x 7 MB available; but one of the 7 MB regions is the recovery image
* 2x 10/100 Mbps Ethernet
* 2T2R 2.4 GHz Wi-Fi
* multi-color LED (controlled via red/green/blue GPIOs)
* 1x GPIO-button (reset)
* external h/w watchdog (enabled by default)
* TTL pins are on board (arrow points to VCC, then follows: GND, TX, RX)
* 2x fast ethernet
- eth0
+ Label: Ethernet 1
+ 24V passive POE (mode B)
+ used as WAN interface
- eth1
+ Label: Ethernet 2
+ 802.3af POE
+ builtin switch port 2
+ used as LAN interface
* 12-24V 1A DC
* external antennas
Flashing instructions:
The tool ap51-flash (https://github.com/ap51-flash/ap51-flash) should be
used to transfer the factory image to the u-boot when the device boots up.
Signed-off-by: Sven Eckelmann <sven@narfation.org>
netgear,wndr4300sw)
ubootenv_add_uci_config "/dev/mtd1" "0x0" "0x40000" "0x20000"
;;
-plasmacloud,pa300)
+plasmacloud,pa300|\
+plasmacloud,pa300e)
ubootenv_add_uci_config "/dev/mtd1" "0x0" "0x40000" "0x40000"
;;
qihoo,c301)
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qca9533_plasmacloud_pa300.dtsi"
+
+/ {
+ compatible = "plasmacloud,pa300e", "qca,qca9533";
+ model = "Plasma Cloud PA300E";
+};
comfast,cf-e314n-v2|\
compex,wpj531-16m|\
plasmacloud,pa300|\
+ plasmacloud,pa300e|\
tplink,cpe210-v1|\
tplink,cpe220-v2|\
tplink,cpe220-v3|\
# boot anymore to Linux until it was reflashed with ap51-flash.
local next_boot_part="1"
case "$(board_name)" in
- plasmacloud,pa300)
+ plasmacloud,pa300|\
+ plasmacloud,pa300e)
primary_kernel_mtd=3
;;
*)
jjplus,ja76pf2)
redboot_fis_do_upgrade "$1" linux
;;
- plasmacloud,pa300)
+ plasmacloud,pa300|\
+ plasmacloud,pa300e)
PART_NAME="inactive"
platform_do_upgrade_dualboot_datachk "$1"
;;
endef
TARGET_DEVICES += plasmacloud_pa300
+define Device/plasmacloud_pa300e
+ $(Device/plasmacloud_pa300-common)
+ DEVICE_MODEL := PA300E
+endef
+TARGET_DEVICES += plasmacloud_pa300e
+
define Device/qihoo_c301
$(Device/seama)
SOC := ar9344