ath79: add support for Compex WPJ563

Specifications:

SoC: QCA9563
DRAM: 128MB DDR2
Flash: 16MB SPI-NOR
2 Gigabit ethernet ports
3×3 2.4GHz on-board radio
miniPCIe slot that supports 5GHz radio
PoE 24V passive or 36V-56V passive with optional IEEE 802.3af/at
USB 3.0 header

Installation:

To install, either start tftp in bin/targets/ath79/generic/ and use
the u-boot prompt over UART:

tftpboot 0x80500000 openwrt-ath79-generic-compex_wpj563-squashfs-sysupgrade.bin
erase 0x9f680000 +1
erase 0x9f030000 +$filesize
cp.b $fileaddr 0x9f030000 $filesize
boot

The cpximg file can be used with sysupgrade in the stock firmware (add
SSH key in luci for root access) or with the built-in cpximg loader.
The cpximg loader can be started either by holding the reset button
during power up or by entering the u-boot prompt and entering 'cpximg'.
Once it's running, a TFTP-server under 192.168.1.1 will accept the image
appropriate for the board revision that is etched on the board.

For example, if the board is labelled '7A02':

tftp -v -m binary 192.168.1.1 -c put openwrt-ath79-generic-compex_wpj563-squashfs-cpximg-7a02.bin

MAC addresses:

<&uboot 0x2e010>  *:71  (label)
<&uboot 0x2e018>  *:72
<&uboot 0x2e020>  *:73
<&uboot 0x2e028>  *:74

Only the first two are used (for ethernet), the WiFi modules have
separate (valid) addresses. The latter two addresses are not used.

Signed-off-by: Leon M. George <leon@georgemail.eu>

diff --git a/target/linux/ath79/dts/qca9563_compex_wpj563.dts b/target/linux/ath79/dts/qca9563_compex_wpj563.dts
new file mode 100644 (file)
index 0000000..ae9dd5c
--- /dev/null
+++ b/target/linux/ath79/dts/qca9563_compex_wpj563.dts
@@ -0,0 +1,145 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca956x.dtsi"
+
+/ {
+       model = "Compex WPJ563";
+       compatible = "compex,wpj563", "qca,qca9563";
+
+       aliases {
+               label-mac-device = &eth0;
+               led-boot = &led_sig4;
+               led-failsafe = &led_sig4;
+               led-running = &led_sig4;
+               led-upgrade = &led_sig4;
+       };
+
+       beeper {
+               compatible = "gpio-beeper";
+               gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
+       };
+
+       keys {
+               compatible = "gpio-keys";
+
+               reset {
+                       label = "reset";
+                       linux,code = <KEY_RESTART>;
+                       gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
+                       debounce-interval = <60>;
+               };
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               sig1 {
+                       label = "wpj563:green:sig1";
+                       gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
+               };
+
+               sig2 {
+                       label = "wpj563:green:sig2";
+                       gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
+               };
+
+               sig3 {
+                       label = "wpj563:green:sig4";
+                       gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
+               };
+
+               led_sig4: sig4 {
+                       label = "wpj563:green:sig4";
+                       gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
+               };
+       };
+};
+
+&pcie {
+       status = "okay";
+};
+
+&spi {
+       status = "okay";
+
+       num-cs = <1>;
+
+       flash@0 {
+               compatible = "jedec,spi-nor";
+               reg = <0>;
+               spi-max-frequency = <25000000>;
+
+               partitions {
+                       compatible = "fixed-partitions";
+                       #address-cells = <1>;
+                       #size-cells = <1>;
+
+                       uboot: partition@0 {
+                               label = "u-boot";
+                               reg = <0x000000 0x030000>;
+                               read-only;
+                       };
+
+                       partition@30000 {
+                               compatible = "denx,uimage";
+                               label = "firmware";
+                               reg = <0x030000 0xfc0000>;
+                       };
+
+                       art: partition@ff0000 {
+                               label = "art";
+                               reg = <0xff0000 0x010000>;
+                               read-only;
+                       };
+               };
+       };
+};
+
+&mdio0 {
+       status = "okay";
+
+       phy-mask = <0>;
+
+       phy0: ethernet-phy@0 {
+               reg = <0>;
+               phy-mode = "sgmii";
+               qca,mib-poll-interval = <500>;
+
+               qca,ar8327-initvals = <
+                       0x04 0x00080080 /* PORT0 PAD MODE CTRL */
+                       0x7c 0x0000007e /* PORT0_STATUS */
+               >;
+       };
+};
+
+&eth0 {
+       status = "okay";
+
+       pll-data = <0x03000101 0x00000101 0x00001919>;
+
+       mtd-mac-address = <&uboot 0x2e010>;
+       phy-mode = "sgmii";
+       phy-handle = <&phy0>;
+};
+
+&usb_phy0 {
+       status = "okay";
+};
+
+&usb0 {
+       status = "okay";
+};
+
+&uart {
+       status = "okay";
+};
+
+&wmac {
+       status = "okay";
+
+       mtd-cal-data = <&art 0x1000>;
+};

diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index e301b6f6163a2b024d5aeff5307631d60f25e116..d99e2ed0ebbf1e2e8dd4e15b240298fa496149f9 100755 (executable)
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -135,7 +135,8 @@ ath79_setup_interfaces()
                ucidef_add_switch "switch0" \
                        "0@eth0" "1:lan" "2:lan" "3:lan" "4:lan" "5:wan" "6@eth1"
                ;;
-       compex,wpj344-16m)
+       compex,wpj344-16m|\
+       compex,wpj563)
                ucidef_add_switch "switch0" \
                        "0@eth0" "3:lan" "2:wan"
                ;;
@@ -383,7 +384,8 @@ ath79_setup_macs()
                lan_mac=$(fritz_tffs -n maca -i $(find_mtd_part "tffs (1)"))
                wan_mac=$(fritz_tffs -n macb -i $(find_mtd_part "tffs (1)"))
                ;;
-       compex,wpj344-16m)
+       compex,wpj344-16m|\
+       compex,wpj563)
                wan_mac=$(mtd_get_mac_binary u-boot 0x2e018)
                ;;
        devolo,magic-2-wifi)

diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index 8dc16983e1cbb4f17c2ea2449bd3127ee7e6e0c9..adc7772c0ed84a32d7ab361cf777bcdad9159303 100644 (file)
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -502,6 +502,18 @@ define Device/compex_wpj531-16m
 endef
 TARGET_DEVICES += compex_wpj531-16m
 
+define Device/compex_wpj563
+  SOC := qca9563
+  DEVICE_PACKAGES := kmod-usb2 kmod-usb3
+  IMAGE_SIZE := 16128k
+  DEVICE_VENDOR := Compex
+  DEVICE_MODEL := WPJ563
+  SUPPORTED_DEVICES += wpj563
+  IMAGES += cpximg-7a02.bin
+  IMAGE/cpximg-7a02.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | append-rootfs | pad-rootfs | mkmylofw_16m 0x694 2
+endef
+TARGET_DEVICES += compex_wpj563
+
 define Device/devolo_dvl1200e
   SOC := qca9558
   DEVICE_VENDOR := devolo