bmips: add support for Netgear EVG2000

The Netgear EVG2000 is a wifi gigabit router, 2.4 GHz single band with
two internal antennas integrated in the main PCB.

Hardware:
 - SoC: Broadcom BCM6369
 - CPU: dual core BMIPS4350 V3.1 @400Mhz
 - RAM: 64 MB DDR
 - Flash: 16 MB parallel NOR
 - LAN switch: Broadcom BCM53115, 5x 1Gbit
 - Wifi 2.4 GHz: Broadcom BCM4322 802.11bgn
 - USB: 2x 2.0
 - Buttons: 2x, 1 reset
 - LEDs: 10x
 - FXS: 2x
 - UART: yes

Installation via CFE web UI:
  1. Power off the router and make a temporal TX-RX shortcircuit on the
     serial pins.
  2. Power on the router and wait 3 or more seconds
  3. Remove the TX-RX shortcircuit
  4. Browse to http://192.168.1.1 or http://192.168.0.1 and upload the
     firmware
  5. Wait a few minutes for it to finish

Signed-off-by: Daniel González Cabanelas <dgcbueu@gmail.com>

diff --git a/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds b/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds
index e68a4e947b182073c84db287d56197202d1f8c94..fb7cca17e5b6b7ed072b326aeebc83bb92b31453 100644 (file)
--- a/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds
+++ b/target/linux/bmips/bcm6368/base-files/etc/board.d/01_leds
@@ -15,6 +15,11 @@ netgear,dgnd3800b)
        ucidef_set_led_usbport "usb1" "USB1" "green:usb1" "usb1-port1" "usb2-port1"
        ucidef_set_led_usbport "usb2" "USB2" "green:usb2" "usb1-port2" "usb2-port2"
        ;;
+netgear,evg2000)
+       ucidef_set_led_netdev "lan" "LAN" "green:lan" "switch.1"
+       ucidef_set_led_netdev "wan" "WAN" "green:wan" "wan"
+       ucidef_set_led_usbdev "usb" "USB" "green:usb" "usb1-port1" "usb2-port1" "usb1-port2" "usb2-port2"
+       ;;
 observa,vh4032n)
        ucidef_set_led_usbport "usb1" "USB1" "blue:hspa" "usb1-port1" "usb2-port1"
        ucidef_set_led_usbport "usb2" "USB2" "red:hspa" "1-2-port1" "1-2-port2"

diff --git a/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network b/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network
index f99005acd722d9e6619d6a1dca59a1f764d25e31..76145024c130ba1c93259d2378a15c76cd0ed58b 100644 (file)
--- a/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network
+++ b/target/linux/bmips/bcm6368/base-files/etc/board.d/02_network
@@ -11,7 +11,8 @@ observa,vh4032n)
        ucidef_set_interface_lan "lan1 lan2 lan3 lan4"
        ;;
 netgear,dgnd3700-v1 |\
-netgear,dgnd3800b)
+netgear,dgnd3800b |\
+netgear,evg2000)
        ucidef_set_bridge_device switch
        ucidef_set_interfaces_lan_wan "lan1 lan2 lan3 lan4" "wan"
        ;;

diff --git a/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc b/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc
index d4ff723d142194230b3a470221a32722dd15f042..363e492594e0408157cada511990ec3c926a9db7 100644 (file)
--- a/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc
+++ b/target/linux/bmips/bcm6368/base-files/etc/uci-defaults/09_fix_crc
@@ -4,6 +4,7 @@
 
 case "$(board_name)" in
 comtrend,vr-3025u |\
+netgear,evg2000 |\
 observa,vh4032n)
        mtd fixtrx firmware
        ;;

diff --git a/target/linux/bmips/dts/bcm6369-netgear-evg2000.dts b/target/linux/bmips/dts/bcm6369-netgear-evg2000.dts
new file mode 100644 (file)
index 0000000..9f03c9e
--- /dev/null
+++ b/target/linux/bmips/dts/bcm6369-netgear-evg2000.dts
@@ -0,0 +1,237 @@
+// SPDX-License-Identifier: GPL-2.0-or-later
+
+#include "bcm6368.dtsi"
+
+/ {
+       model = "Netgear EVG2000";
+       compatible = "netgear,evg2000", "brcm,bcm6369", "brcm,bcm6368";
+
+       aliases {
+               led-boot = &led_power_green;
+               led-failsafe = &led_power_red;
+               led-running = &led_power_green;
+               led-upgrade = &led_power_green;
+       };
+
+       keys {
+               compatible = "gpio-keys-polled";
+               poll-interval = <100>;
+
+               reset {
+                       label = "reset";
+                       gpios = <&gpio 25 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_RESTART>;
+                       debounce-interval = <60>;
+               };
+
+               wps {
+                       label = "wps";
+                       gpios = <&gpio 26 GPIO_ACTIVE_LOW>;
+                       linux,code = <KEY_WPS_BUTTON>;
+                       debounce-interval = <60>;
+               };
+       };
+
+       leds {
+               compatible = "gpio-leds";
+
+               led@2 {
+                       label = "green:voip2";
+                       gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
+               };
+
+               led@4 {
+                       label = "red:internet";
+                       gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
+               };
+
+               led@5 {
+                       label = "green:internet";
+                       gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
+               };
+
+               led@14 {
+                       label = "green:voip1";
+                       gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+               };
+
+               led@15 {
+                       label = "green:usb";
+                       gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+               };
+
+               led_power_green: led@22 {
+                       label = "green:power";
+                       gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
+                       default-state = "on";
+               };
+
+               led_power_red: led@23 {
+                       label = "red:power";
+                       gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
+               };
+
+               led@24 {
+                       label = "green:lan";
+                       gpios = <&gpio 24 GPIO_ACTIVE_LOW>;
+               };
+
+               led@27 {
+                       label = "green:wan";
+                       gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
+               };
+       };
+
+       bcm4322-sprom {
+               compatible = "brcm,ssb-sprom";
+
+               pci-bus = <0>;
+               pci-dev = <1>;
+
+               nvmem-cells = <&macaddr_cfe_6a0>;
+               nvmem-cell-names = "mac-address";
+               mac-address-increment = <1>;
+
+               brcm,sprom = "brcm/bcm4322-sprom.bin";
+               brcm,sprom-fixups = <219 0xec08>;
+       };
+};
+
+&ehci {
+       status = "okay";
+};
+
+&ethernet {
+       status = "okay";
+
+       nvmem-cells = <&macaddr_cfe_6a0>;
+       nvmem-cell-names = "mac-address";
+};
+
+&mdio_ext {
+       switch@1e {
+               compatible = "brcm,bcm53115";
+               reg = <30>;
+
+               dsa,member = <1 0>;
+
+               ports {
+                       #address-cells = <1>;
+                       #size-cells = <0>;
+
+                       port@0 {
+                               reg = <0>;
+                               label = "wan";
+                       };
+
+                       port@1 {
+                               reg = <1>;
+                               label = "lan1";
+                       };
+
+                       port@2 {
+                               reg = <2>;
+                               label = "lan2";
+                       };
+
+                       port@3 {
+                               reg = <3>;
+                               label = "lan3";
+                       };
+
+                       port@4 {
+                               reg = <4>;
+                               label = "lan4";
+                       };
+
+                       port@8 {
+                               reg = <8>;
+
+                               phy-mode = "rgmii";
+                               ethernet = <&switch0port5>;
+
+                               fixed-link {
+                                       speed = <1000>;
+                                       full-duplex;
+                               };
+                       };
+               };
+       };
+};
+
+&switch0 {
+       dsa,member = <0 0>;
+
+       ports {
+               switch0port5: port@5 {
+                       reg = <5>;
+                       label = "extsw";
+
+                       phy-mode = "rgmii";
+
+                       fixed-link {
+                               speed = <1000>;
+                               full-duplex;
+                       };
+               };
+       };
+};
+
+&pflash {
+       status = "okay";
+
+       partitions {
+               compatible = "fixed-partitions";
+               #address-cells = <1>;
+               #size-cells = <1>;
+
+               cfe: partition@0 {
+                       label = "CFE";
+                       reg = <0x000000 0x020000>;
+                       read-only;
+               };
+
+               partition@20000 {
+                       label = "firmware";
+                       reg = <0x020000 0xf40000>;
+                       compatible = "brcm,bcm963xx-imagetag";
+               };
+
+               partition@f60000 {
+                       label = "board_data";
+                       reg = <0xf60000 0x080000>;
+                       read-only;
+               };
+
+               partition@fe0000 {
+                       label = "nvram";
+                       reg = <0xfe0000 0x020000>;
+               };
+       };
+};
+
+&ohci {
+       status = "okay";
+};
+
+&pci {
+       status = "okay";
+};
+
+&uart0 {
+       status = "okay";
+};
+
+&usbh {
+       status = "okay";
+};
+
+&cfe {
+       compatible = "nvmem-cells";
+       #address-cells = <1>;
+       #size-cells = <1>;
+
+       macaddr_cfe_6a0: macaddr@6a0 {
+               reg = <0x6a0 0x6>;
+       };
+};

diff --git a/target/linux/bmips/image/bcm6368.mk b/target/linux/bmips/image/bcm6368.mk
index 41bce9e938c8dc78fab9b9eb8e70b697e0392bed..82d7608fba26fa5e99344b4f3264177b3c970729 100644 (file)
--- a/target/linux/bmips/image/bcm6368.mk
+++ b/target/linux/bmips/image/bcm6368.mk
@@ -43,6 +43,21 @@ define Device/netgear_dgnd3800b
 endef
 TARGET_DEVICES += netgear_dgnd3800b
 
+define Device/netgear_evg2000
+  $(Device/bcm63xx_netgear)
+  DEVICE_MODEL := EVG2000
+  CFE_BOARD_ID := 96369PVG
+  CHIP_ID := 6368
+  SOC := bcm6369
+  BLOCKSIZE := 0x20000
+  NETGEAR_BOARD_ID := U12H154T90_NETGEAR
+  NETGEAR_REGION := 1
+  DEVICE_PACKAGES += $(USB2_PACKAGES) \
+    $(B43_PACKAGES) broadcom-4322-sprom \
+    kmod-leds-gpio
+endef
+TARGET_DEVICES += netgear_evg2000
+
 define Device/observa_vh4032n
   $(Device/bcm63xx-cfe)
   DEVICE_VENDOR := Observa