#define PCMMIO_AO_RESOURCE_ENA_REG 0x0b
#define PCMMIO_AO_2ND_DAC_OFFSET 0x04
+/*
+ * WinSystems WS16C48
+ *
+ * Offset Page 0 Page 1 Page 2 Page 3
+ * ------ ----------- ----------- ----------- -----------
+ * 0x10 Port 0 I/O Port 0 I/O Port 0 I/O Port 0 I/O
+ * 0x11 Port 1 I/O Port 1 I/O Port 1 I/O Port 1 I/O
+ * 0x12 Port 2 I/O Port 2 I/O Port 2 I/O Port 2 I/O
+ * 0x13 Port 3 I/O Port 3 I/O Port 3 I/O Port 3 I/O
+ * 0x14 Port 4 I/O Port 4 I/O Port 4 I/O Port 4 I/O
+ * 0x15 Port 5 I/O Port 5 I/O Port 5 I/O Port 5 I/O
+ * 0x16 INT_PENDING INT_PENDING INT_PENDING INT_PENDING
+ * 0x17 Page/Lock Page/Lock Page/Lock Page/Lock
+ * 0x18 N/A POL_0 ENAB_0 INT_ID0
+ * 0x19 N/A POL_1 ENAB_1 INT_ID1
+ * 0x1a N/A POL_2 ENAB_2 INT_ID2
+ */
+#define PCMMIO_PORT_REG(x) (0x10 + (x))
+#define PCMMIO_INT_PENDING_REG 0x16
+#define PCMMIO_PAGE_LOCK_REG 0x17
+#define PCMMIO_LOCK_PORT(x) ((1 << (x)) & 0x3f)
+#define PCMMIO_PAGE(x) (((x) & 0x3) << 6)
+#define PCMMIO_PAGE_MASK PCMUIO_PAGE(3)
+#define PCMMIO_PAGE_POL 1
+#define PCMMIO_PAGE_ENAB 2
+#define PCMMIO_PAGE_INT_ID 3
+#define PCMMIO_PAGE_REG(x) (0x18 + (x))
+
/* This stuff is all from pcmuio.c -- it refers to the DIO subdevices only */
#define CHANS_PER_PORT 8
#define PORTS_PER_ASIC 6
#define ASIC_IOSIZE (0x0B)
#define PCMMIO48_IOSIZE ASIC_IOSIZE
-/* Some offsets - these are all in the 16byte IO memory offset from
- the base address. Note that there is a paging scheme to swap out
- offsets 0x8-0xA using the PAGELOCK register. See the table below.
-
- Register(s) Pages R/W? Description
- --------------------------------------------------------------
- REG_PORTx All R/W Read/Write/Configure IO
- REG_INT_PENDING All ReadOnly Quickly see which INT_IDx has int.
- REG_PAGELOCK All WriteOnly Select a page
- REG_POLx Pg. 1 only WriteOnly Select edge-detection polarity
- REG_ENABx Pg. 2 only WriteOnly Enable/Disable edge-detect. int.
- REG_INT_IDx Pg. 3 only R/W See which ports/bits have ints.
- */
-#define REG_PORT0 0x0
-#define REG_PORT1 0x1
-#define REG_PORT2 0x2
-#define REG_PORT3 0x3
-#define REG_PORT4 0x4
-#define REG_PORT5 0x5
-#define REG_INT_PENDING 0x6
-#define REG_PAGELOCK 0x7 /*
- * page selector register, upper 2 bits select
- * a page and bits 0-5 are used to 'lock down'
- * a particular port above to make it readonly.
- */
-#define REG_POL0 0x8
-#define REG_POL1 0x9
-#define REG_POL2 0xA
-#define REG_ENAB0 0x8
-#define REG_ENAB1 0x9
-#define REG_ENAB2 0xA
-#define REG_INT_ID0 0x8
-#define REG_INT_ID1 0x9
-#define REG_INT_ID2 0xA
-
#define NUM_PAGED_REGS 3
#define NUM_PAGES 4
#define FIRST_PAGED_REG 0x8
-#define REG_PAGE_BITOFFSET 6
-#define REG_LOCK_BITOFFSET 0
-#define REG_PAGE_MASK (~((0x1<<REG_PAGE_BITOFFSET)-1))
-#define REG_LOCK_MASK (~(REG_PAGE_MASK))
-#define PAGE_POL 1
-#define PAGE_ENAB 2
-#define PAGE_INT_ID 3
static const struct comedi_lrange pcmmio_ai_ranges = {
4, {
* feel free to suggest moving the variable to the struct comedi_device struct.
*/
struct pcmmio_private {
- unsigned long asic_iobase;
spinlock_t spinlock;
struct pcmmio_subdev_private *sprivs;
static void switch_page(struct comedi_device *dev, int page)
{
- struct pcmmio_private *devpriv = dev->private;
-
- outb(page << REG_PAGE_BITOFFSET, devpriv->asic_iobase + REG_PAGELOCK);
+ outb(PCMMIO_PAGE(page), dev->iobase + PCMMIO_PAGE_LOCK_REG);
}
static void pcmmio_reset(struct comedi_device *dev)
{
- struct pcmmio_private *devpriv = dev->private;
- unsigned long baseaddr = devpriv->asic_iobase;
int port, page;
switch_page(dev, 0); /* switch back to page 0 */
/* first, clear all the DIO port bits */
for (port = 0; port < PORTS_PER_ASIC; ++port)
- outb(0, baseaddr + REG_PORT0 + port);
+ outb(0, dev->iobase + PCMMIO_PORT_REG(port));
/* Next, clear all the paged registers for each page */
for (page = 1; page < NUM_PAGES; ++page) {
int reg;
/* now clear all the paged registers */
switch_page(dev, page);
- for (reg = FIRST_PAGED_REG;
- reg < FIRST_PAGED_REG + NUM_PAGED_REGS; ++reg)
- outb(0, baseaddr + reg);
+ for (reg = 0; reg < NUM_PAGED_REGS; ++reg)
+ outb(0, dev->iobase + PCMMIO_PAGE_REG(reg));
}
/* switch back to default page 0 */
static void pcmmio_stop_intr(struct comedi_device *dev,
struct comedi_subdevice *s)
{
- struct pcmmio_private *devpriv = dev->private;
int nports, firstport, asic, port;
asic = subpriv->dio.intr.asic;
s->async->inttrig = NULL;
nports = subpriv->dio.intr.num_asic_chans / CHANS_PER_PORT;
firstport = subpriv->dio.intr.asic_chan / CHANS_PER_PORT;
- switch_page(dev, PAGE_ENAB);
+ switch_page(dev, PCMMIO_PAGE_ENAB);
for (port = firstport; port < firstport + nports; ++port) {
/* disable all intrs for this subdev.. */
- outb(0, devpriv->asic_iobase + REG_ENAB0 + port);
+ outb(0, dev->iobase + PCMMIO_PAGE_REG(port));
}
}
if (irq == dev->irq) {
unsigned long flags;
unsigned triggered = 0;
- unsigned long iobase = devpriv->asic_iobase;
/* it is an interrupt for ASIC #asic */
unsigned char int_pend;
spin_lock_irqsave(&devpriv->spinlock, flags);
- int_pend = inb(iobase + REG_INT_PENDING) & 0x07;
+ int_pend = inb(dev->iobase + PCMMIO_INT_PENDING_REG);
+ int_pend &= 0x07;
if (int_pend) {
int port;
if (int_pend & (0x1 << port)) {
unsigned char
io_lines_with_edges = 0;
- switch_page(dev, PAGE_INT_ID);
+ switch_page(dev, PCMMIO_PAGE_INT_ID);
io_lines_with_edges =
- inb(iobase +
- REG_INT_ID0 + port);
+ inb(dev->iobase +
+ PCMMIO_PAGE_REG(port));
if (io_lines_with_edges)
/*
* clear pending
* interrupt
*/
- outb(0, iobase +
- REG_INT_ID0 +
- port);
+ outb(0, dev->iobase +
+ PCMMIO_PAGE_REG(port));
triggered |=
io_lines_with_edges <<
static int pcmmio_start_intr(struct comedi_device *dev,
struct comedi_subdevice *s)
{
- struct pcmmio_private *devpriv = dev->private;
-
if (!subpriv->dio.intr.continuous && subpriv->dio.intr.stop_count == 0) {
/* An empty acquisition! */
s->async->events |= COMEDI_CB_EOA;
/* done, we told the board what irq to use */
}
- switch_page(dev, PAGE_ENAB);
+ switch_page(dev, PCMMIO_PAGE_ENAB);
for (port = firstport; port < firstport + nports; ++port) {
unsigned enab =
bits >> (subpriv->dio.intr.first_chan + (port -
pol_bits >> (subpriv->dio.intr.first_chan +
(port - firstport) * 8) & 0xff;
/* set enab intrs for this subdev.. */
- outb(enab, devpriv->asic_iobase + REG_ENAB0 + port);
- switch_page(dev, PAGE_POL);
- outb(pol, devpriv->asic_iobase + REG_ENAB0 + port);
+ outb(enab, dev->iobase + PCMMIO_PAGE_REG(port));
+ switch_page(dev, PCMMIO_PAGE_POL);
+ outb(pol, dev->iobase + PCMMIO_PAGE_REG(port));
}
}
return 0;
if (!devpriv)
return -ENOMEM;
- devpriv->asic_iobase = dev->iobase + 16;
spin_lock_init(&devpriv->spinlock);
chans_left = CHANS_PER_ASIC * 1;
++asic;
thisasic_chanct = 0;
}
- subpriv->iobases[byte_no] = devpriv->asic_iobase + port;
+ subpriv->iobases[byte_no] = dev->iobase +
+ PCMMIO_PORT_REG(port);
if (thisasic_chanct <
CHANS_PER_PORT * INTR_PORTS_PER_ASIC