[PATCH] yenta TI: turn off interrupts during card power-on #2

[PATCH] yenta TI: turn off interrupts during card power-on #2

- make boot-up card recognition more reliable (ie.  redo interrogation
  always if there is no valid 'card inserted' state) (and yes, i saw it
  happening on an o2micro controller that both CB_CBARD and CB_16BITCARD
  bits were set at the same time)

- also redo interrogation before probing the ISA interrupts.  it's safer
  to do the probing with the socket in a clean state.

- make card insert detect more reliable.  yenta_get_status() now returns
  SS_PENDING as long as the card is not completley inserted and one of the
  voltage bits is set.  also !CB_CBARD doesn't mean CB_16BITCARD.  there is
  CB_NOTACARD as well, so make an explicit check for CB_16BITCARD.

- for TI bridges: disable IRQs during power-on.  in all-serial and tied
  interrupt mode the interrupts are always disabled for single-slot
  controllers.  for two-slot contollers the disabling is only done when the
  other slot is empty.  to force disabling there is a new module parameter
  now: pwr_irqs_off=Y (which is a regression for working setups.  that's
  why it's an option, only use when required)

- modparm to disable ISA interrupt probing (isa_probe, defaults to on)

- remove unneeded code/cleanups (ie.  merge yenta_events() into
  yenta_interrupts())

Signed-off-by: Daniel Ritz <daniel.ritz@gmx.ch>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>